You are browsing camaro5 
 |
|
07-27-2023, 08:42 AM
|
#15 |
        
Drives: 2010 Turbo LS3 Join Date: Dec 2009
Location: Palm Bay, FL
Posts: 2,736
|
You have to tape off the area, measure your placement 167 times, sedate yourself to reduce the anxiety of drilling the first hole and cut along the lines you created on the tape. I used an air saw, some use a cutoff wheel, but the hood is aluminum, so a wheel might clog some. I went with smaller vents that are outside the stripes. I also bought different hardware with nylock nuts to be sure it would not loosen up and I put a very small amount of sealant around the mounting surface to reduce potential vibration.
Be careful not to overtighten the screws as that will create small ripples in the sheet metal. Also think about what you are going to do about the insulation on the underside of the of the hood.
__________________
2010 SS - On3 kit with downpipe cutout, CTR 78/80, CompCam 239/251 620/632 122+4, E85, Z28 suspension and ZL1 diff with Outlaw axles. Gen6 ZL1/1LE brakes.
2011 Vert - 416/w 230/236 .612/.602 115lsa, 1LE suspension w/32mm rear bar. Z28 diff. ZL1 brakes. |
|
|
|
07-30-2023, 05:03 AM
|
#16 |
|
LSx FTW!!!
Drives: 2010 Camaro 2SS RS Join Date: Jan 2017
Location: TN
Posts: 767
|
Just seen a install video on these vents.
Not sure I can cut that out myself. Probably just pay a body shop to do that so I don't mess it up!
__________________
2010 2SS RS A6 781rwhp on E85
Stage 2 ProCharger D1X Circle D 3400 Triple Disc Kooks Jet Hot Headers Kooks Full 3in exhaust Trick Flow GenX 255's Polished PAC .660's & Ti-retainers TSP VVT 3.2 cam kit w/DoD Delete Smith Bro's Trunnion kit AEM X-Series OBDII Widebands FIC ID1300x Injectors GM ZL1 High Output Fuel Pump DSX Tuning Flex Sensor DSX Auxiliary Fuel System Tim King Stage 4 Max Effort CTSV 6L90 DSS 1 piece aluminum driveshaft JRE 6L80E / 6L90E Dipstick NGK Iridium IX spark plugs #7 heat range Mighty Mouse Camaro 5 Wild w/-12an and Billet Black HP Tuners VCM Suite |
|
|
|
|
|
|
|
 |
|
|
