03-16-2013, 09:57 AM | #1 |
Drives: 2010 camaro SS Join Date: Feb 2013
Location: New york
Posts: 2
|
Rear speaker help
Hey, almost finished installing my Infinity Kappa 693.9i - Car speaker - 110 Watt - 3-way - 6" x 9" for the rear speakers, but I am having trouble figuring out how to connect the old harness wires to the new speakers . I have the speaker harness from ******** , but since they don't fit , I'm assuming they are only for the front speakers. The 6x9 in the back harness is almost double the front it seems
|
03-16-2013, 03:55 PM | #2 |
Drives: Black 2011 2SS/RS / Black 2013 ZL1 Join Date: Feb 2012
Location: El Paso, Texas
Posts: 314
|
Does sound like you have the adapters for the front speakers. The harness adapters for the rear speakers should have four wires. You only use the two gray ones but each harness should have four wires.
|
03-17-2013, 06:43 AM | #3 |
Drives: 2010 camaro SS Join Date: Feb 2013
Location: New york
Posts: 2
|
It was the harness adapter from ******** , but it's smaller than the back speaker wire adapter. Ill take pictures on my lunch break. But where do you get the rear speaker adapter for the Boston acoustic system from ?
|
03-17-2013, 11:15 AM | #4 |
Drives: Black 2011 2SS/RS / Black 2013 ZL1 Join Date: Feb 2012
Location: El Paso, Texas
Posts: 314
|
******** sells those harnesses. I believe they're called X2a. If you're looking to replace your Boston amp, ******** sells the FARK harness, which includes a set of X2a harnesses for your 6×9's. Those harnesses from ******** eliminate having to cut/tap into your existing wiring. ******** also sells the speaker mounts/adapters for your front door speakers and rear 6×9's. You're going to need some for your 6×9's for sure. The holes left behind by your stock 6×9's are bigger than most after market 6×9's.
|
|
|
Tags |
boston acoustics, harness, i'm a noob, speakers, wiring |
|
|