[GreggMac]

Hi, I'm looking to add a hellion twin turbo kit, Texas speed cam, CAI, corsa Xtreme+ exhaust, and kooks headers. What other supporting mods would I need to get to reach the elusive "1200 HP" that Hellion says is capable? Also where would I get a torque converter that would be able to handle this amount of power?

[KingLT1]

pistons, rods, fuel system, main studs, drive line upgrades, and suspension. about another 25-30k on top of the cost of purchasing the car to make 1200hp done right.

[kropscamaro16]

Originally Posted by KingLT1

pistons, rods, fuel system, main studs, drive line upgrades, and suspension. about another 25-30k on top of the cost of purchasing the car to make 1200hp done right.

lol pretty much but na just throw the twin turbo kit on and tune it for 30lbs of boost hell be fine dont worry!!

[crosive]

you can cross kooks headers off your list, the hellion kit comes with it's own manifolds.

Why do you want 1200hp? look up guitarmageddon zl1 on youtube. he has a zl1 with a texas speed 416, hellion kit, among other things I forget about. He's around 1000 whp I believe

[GreggMac]

Originally Posted by KingLT1

pistons, rods, fuel system, main studs, drive line upgrades, and suspension. about another 25-30k on top of the cost of purchasing the car to make 1200hp done right.

where would i get a torque converter for the a10? everywhere i look there seem to be none for it

[appleman22]

Never heard of someone putting a turbo on a "camero"

[Markoz28]

That much power you are well into the realm of breaking everything and will need all of it. No headers or CAI as the turbo kit will take care of all that. Fuel, lots and lots of fuel. Complete forged engine. All new and stronger drive line.

[95 imp]

Originally Posted by GreggMac

Hi, I'm looking to add a hellion twin turbo kit, Texas speed cam, CAI, corsa Xtreme+ exhaust, and kooks headers. What other supporting mods would I need to get to reach the elusive "1200 HP" that Hellion says is capable? Also where would I get a torque converter that would be able to handle this amount of power?

How about a check with a lot of zeros at the end.....


And, you can scratch the cam, CAI, and headers off your list, unless you plan to put those turbos and the CAI(s) next to your tranny.

[Juiced1]

It's easy to make around 600rwhp with these cars but after that stuff starts to get expensive real quick. 650-750rwhp you'll need LT4 fuel system upgrades and you'll really be pushing the stock bottom end. Anything above that 750rwhp you need a forged bottom end and complete big dollar fuel system most likely with a port injection system or a ton of meth. Anything in the 1000hp range is going to break a lot of stuff too. So be prepared to break the rear end and trans. We have everything needed to get you there, if you're serious give us a call.