04-08-2013, 08:51 AM | #1 |
Coupe Newbie
Drives: 2017 ZL1, 2021 Corvette Convertible Join Date: Jul 2011
Location: Columbus, Ohio
Posts: 3,291
|
Remove bow tie from ZL1 front grill?
What's the best way to remove the bow tie from the ZL1 front grill so I can custom paint it?
__________________
|
04-08-2013, 10:41 AM | #2 |
Perma Grinning
Drives: 2012 Tom Henry Racing ZL1 Join Date: Feb 2012
Location: Schaumburg, IL
Posts: 452
|
Not sure the "best" way . . . I know there are three clips . . . would need to get to the back side of the bow tie and push them out.
|
04-08-2013, 11:02 AM | #3 |
Coupe Newbie
Drives: 2017 ZL1, 2021 Corvette Convertible Join Date: Jul 2011
Location: Columbus, Ohio
Posts: 3,291
|
I can get to the left and right clips by sticking my finger through the grill slots. The top clip, however, appears unreachable from the front of the grill. I'm trying to find a way to remove it without having to remove the radiator cover.
__________________
|
04-08-2013, 11:10 AM | #4 |
Mid-Florida Camaro Club
Drives: 2019 ZL1 on Order Join Date: Jan 2011
Location: Heathrow, FL
Posts: 3,136
|
you need to remove the radiator shroud and then reach your hand in to release the clips from above.
Only takes a few minutes to pop it out
__________________
|
04-08-2013, 11:12 AM | #5 | |
Drives: 2016 Camaro 2SS, Nightfall Grey Join Date: Nov 2012
Location: Sulphur La.
Posts: 1,680
|
On the ZL!'s there are only 3 tangs on the back bow tie, you will need to break one off. Don't remember if it's the middle upper or middle lower
__________________
2016 Camaro 2SS, Nightfall Grey,
MRC, NPP, S/R, Nav, A8, E-Force Supercharged. Last edited by E-Ray; 04-08-2013 at 11:23 AM. |
|
04-08-2013, 11:20 AM | #6 |
Drives: C6 Z51, 1971 Chevelle SS Join Date: Jun 2011
Location: Sherwood Park
Posts: 36
|
No need to remove the radiator shroud, I used a 25 cm (10 inch) long flat head screwdriver (can probably use something of similar length), inserted in the opening of the hood latch on the shroud and pushed all 3 clips, one at a time. Easy takes about 30 secs.
|
04-08-2013, 11:33 AM | #7 |
Coupe Newbie
Drives: 2017 ZL1, 2021 Corvette Convertible Join Date: Jul 2011
Location: Columbus, Ohio
Posts: 3,291
|
Thank you! This is exactly the info I was looking for. Now I just have find a long flat head screw driver.
__________________
|
04-08-2013, 12:28 PM | #8 |
Drives: C6 Z51, 1971 Chevelle SS Join Date: Jun 2011
Location: Sherwood Park
Posts: 36
|
No problem, just did mine on the weekend. Just make sure it has at least a 10 inch reach (not including handle) and it shouldn't be a problem.
|
|
|
|
|