Finished Mucking Around With Lights

[camguynj]

Originally Posted by johndm

I do NOT have the Halo harness, so my Halo's and side markers only come on when the control is moved to parking lamps only, or automatically along with the headlights.

I assume your harness adds the Halo's to the daytime DRL's?

If you want the front side markers on only at night you will need to tap into the rear parking lamps circuit so they only come on with the tail lights?

Guess it means just running the one wire from the module to the rear parking lamp circuit

To be safe I'd contact a decent auto electrical guy as you don't want to damage the BCM if you short something out?

Cheers,

J

The Always-on halo harness is just for the Halos. The DRLs have a separate Always-on harness. Good idea about using the rear parking lamp. Might give it a try.

[camguynj]

Finally got the DRL-1 flashing sidemarker module installed Tapped into the factory halo feed before the Always-on halo harness and all good. Here's a link to my install post. Very pleased.
http://www.camaro5.com/forums/showth...16#post9737416

[dako94]

I want to have in the rear switchback turn Signal to
What i Need for this ?

[johndm]

Originally Posted by dako94

I want to have in the rear switchback turn Signal to
What i Need for this ?

???

[dako94]

Sorry for my bad english i Come Frome Germany. I want to have Rear Outers Red Tail Light and Amber Turn Signal, Switchback LEDs.
And my question is: what i need to have this ? Harness ?

[camguynj]

Originally Posted by dako94

Sorry for my bad english i Come Frome Germany. I want to have Rear Outers Red Tail Light and Amber Turn Signal, Switchback LEDs.
And my question is: what i need to have this ? Harness ?

What year is your car?

[dako94]

Originally Posted by camguynj

What year is your car?

Gen5 1ss 6,2 2013

[camguynj]

Originally Posted by dako94

Sorry for my bad english i Come Frome Germany. I want to have Rear Outers Red Tail Light and Amber Turn Signal, Switchback LEDs.
And my question is: what i need to have this ? Harness ?

In order to have switchback functionality you will first have to find LEDs that have dual filaments, one for each color ( red, Amber) and then rewire the pins in the connectors to each separate filament. There is no harness available to do this. You’ll also have to wire in load resistors to keep the LEDs from hyperflashing.

[johndm]

Originally Posted by dako94

Sorry for my bad english i Come Frome Germany. I want to have Rear Outers Red Tail Light and Amber Turn Signal, Switchback LEDs.
And my question is: what i need to have this ? Harness ?

Are you currently converted to rear outers amber signal only with inners as tail/brake?