09-24-2014, 09:33 AM | #1 |
Drives: 2009 Corvette ZR1 Join Date: Aug 2012
Location: On the coast North of SFBay
Posts: 295
|
Need some measurments
Just picked up a 2014 SS donor with L99 and I'm now looking for the Gen 1 Camaro to install some or all of that stuff from the donor.
Would any of you be willing to measure the width between the door panels and the width between the A-pillars at the point where they meet the dash? TIA |
09-30-2014, 08:25 AM | #2 |
Drives: 2009 Corvette ZR1 Join Date: Aug 2012
Location: On the coast North of SFBay
Posts: 295
|
I know at least on of you guys has a tape measure - LOL
|
10-03-2014, 06:10 AM | #3 |
Account Suspended
Drives: car Join Date: May 2008
Location: location
Posts: 1,574
|
Been trying to remember to do this when I get home (at work), keep forgetting. I'll TRY to remember and get them for you soon! Sorry!
|
10-04-2014, 04:58 PM | #4 |
Not easy being Green
Drives: 67 Nova SS Join Date: Nov 2008
Location: Olympia, WA
Posts: 2,256
|
The dash top panel 55" on my 68, the A pillars inside to inside 55 1/8"
The A pillars will very about 1/8" pending on were you take the measurement from, because of how its stamped. This should get you close. This was without the A pillar post moldings.
__________________
|
10-04-2014, 05:39 PM | #5 |
Drives: 2009 Corvette ZR1 Join Date: Aug 2012
Location: On the coast North of SFBay
Posts: 295
|
Thanks buddy, that's good news for my upcoming project. Bought a wrecked 2014 2SS/Nav L99 and hope to put the suspension, driveline, dash and interior into a 68 or 69. The 14 is 55-3/4 with room to trim
|
|
|
Thread Tools | |
|
|