10-13-2011, 04:02 PM | #15 |
Drives: 2010 camaro ss Join Date: May 2009
Location: Tacoma WA
Posts: 779
|
you assume the dealer is knowingly giving a broke car back?Sounds like it ran well for 2 weeks before another symptom,should they hold onto your car for 2 weeks before they think its fixed?Jesus get a clue,there are no crystal balls or magic wands intermitent electrical problems are by far the worst to locate give these guys a break there doing there best and you playing the fool is not making it better
|
10-20-2011, 02:39 AM | #16 |
Drives: 2010 2ss ss/rs abm, 2016 2ss/rs hbm Join Date: Feb 2009
Location: N. Phx, Az
Posts: 1,332
|
Are you setting any MAP sensor codes? I was getting an intermitant MAP sensor code p0107 and it would trigger a service stabilitrac warning, the car would run like crap and if it stalled or I shut it off it would crank but not restart. Traced it down to some harness damage by the starter and starter heat shield and the right rear back of block. It was very hard to see and really tight, I managed to reposition those harnesses and the problem went away. After 700 miles of no more issues I took it to the dealer, showed them the issue, they repaired and rerouted those harnesses and its been fine since.
__________________
URR2SLO - If you're not going fast enough, get out the way......
|
10-20-2011, 07:39 AM | #17 |
Drives: CGM,twin turbo, cam 2010 SS/RS Join Date: Mar 2011
Location: ROCKMART, GA
Posts: 2,185
|
Most of the time if your getting relay chatter it means there isnt enought voltage there to close the relay or could just be a bad relay.
|
11-01-2011, 10:54 AM | #18 |
Drives: 2011 camaro Join Date: Oct 2011
Location: Ga
Posts: 2
|
Service stabilitrak-car wont start-wont change gears
I have a 2011 camaro, which in the shop for the 3rd time and i haven't even had it a year.. I was wondering if anyone had experienced the intermittent problem of when you try to start the car "service stabilitrak" displays and the car doesn't even attempt to turn over or make any noise, after a few attempts of turning the key off and on, the car finally starts BUT still displays the service stabilitrak message and the engine light comes on, when you start to drive,it doesn't switch gears, i can be going 25-30mph and the rpms are all the way up to 4,000 and the car never shifts and runs VERY loudly, then when I let off the gas it takes FOREVER for the RPMs to come back down. I can shut the car off a few times and try to drive it again and it will still do it, then i can stop and restart and its GONE. When i took it to the dealer it didn't leave any codes, they had it for 3 days and were clueless.
The other problem my car has, which is the second time I'm having this fixed, is getting the " Ac off due to high engine temp" my car had been sitting in the garage for 10 hours and displayed this messgage upon starting the car. thermostat gauge doesn't work and I get no digital temperatue on my dash controls either, but the car never over heats. |
02-22-2013, 03:07 PM | #19 |
Drives: 2011 SS ZL427 Join Date: Feb 2013
Location: Drums PA
Posts: 115
|
Considering a Mustang youll be in the same boat the Mustangs are having problems to especially with Reverse in the Transmissions and electrical issues its not the Car these days thats the problem its the Federal Government breathing down these automakers back for lighter more fuel efficient cars thats why we have this nonsense with cylinder deactivation on the automatic V8's to turn it into a 4 Cylinder, it is rediculous a V8 should be a V8 if you want economy by a V6 there forcing the manufacturers to install all this nonsense on the car that will only end up breaking and causing us problems you want to blame someone blame the Government.
__________________
|
02-22-2013, 04:02 PM | #20 |
Drives: 2010 Camaro 2SS/RS +2014 El Tigre Join Date: Mar 2011
Location: South West Michigan
Posts: 344
|
I know this is an old thread but, I had a the same problem right after I installed my headers and tune. At first I thought it was the tune? Nope, it was the positive battery cable on the driver side coming in contact with the header! It melted and would short out periodically causing it to turn off and flash that same message!
|
02-23-2013, 07:16 PM | #21 | |
Drives: 2011 camaro Join Date: Feb 2013
Location: Nj
Posts: 3
|
Look at drive side drain by cowl itt leaks into harness remove wiper trans sidodraini
Quote:
Last edited by Raycole; 02-23-2013 at 07:23 PM. Reason: Second thing goes wrong throttle pedal position switch has 2 switches inside set code causes same thing |
|
09-14-2018, 12:55 PM | #22 |
Drives: 2000 SS Join Date: May 2011
Location: San Antonio
Posts: 30
|
Anyone figure this issue. Exact same thing happening to our car. That stabilitrack message comes on and car doesn't start. Tried new battery
|
09-14-2018, 12:56 PM | #23 |
Drives: 2000 SS Join Date: May 2011
Location: San Antonio
Posts: 30
|
2010 Camaro v6
|
04-14-2021, 03:46 PM | #24 |
Drives: 2015 ZL1 Join Date: Oct 2015
Location: Yuma
Posts: 77
|
2015 ZL1 no crank-Service Stabilitrac on message screen
I know this is an old thread, but I'm having the same issue with my 2015 ZL1. Only fix that I've found is to disconnect positive battery cable for 30 seconds and then it will crank right up. First time it happened was when I first bought it and they replaced the control module. But car is now out of warranty (extended GMPP expired last year) and it's acting up. Has anyone found the cause? The car is garage kept and hasn't seen rain in over a month, so I doubt it's a water leak like someone mentioned. It's also never done it after being washed. If it was once a year, I could live with it, but it's done it three times since last Monday.
__________________
"Too much horsepower is almost enough!!!"
Current Vehicles; 2015 ZL1 Ashen Gray, A6, #1130, built 4/9/15 2014 Ram Laramie Hemi 4x4 1970 Nova Black ZZ502/TH400 |
10-30-2022, 09:19 PM | #25 |
Drives: 2010 Camero SS2 , 1972 C10 Join Date: Oct 2022
Location: Scottsdale Az
Posts: 1
|
This is my first attempt at posting . Thanks for admitting us to the group. We just put an LS3 that we purchased as a drop out (?) Manual Transmission, hoses, everything attached into our 2010 Camaro ss2 . My issue is we can’t get it to start. The lights come on including the gages it sounds like the starter clicks but she doesn’t even try to start.
Does the computer need to reset ? Any advice is appreciated. We have checked all connections, confirmed power is getting where it needs to. Thanks |
10-30-2022, 10:43 PM | #26 |
Drives: 2012 Chevrolet Camaro l99 Join Date: Aug 2020
Location: Austin, TX
Posts: 2,100
|
I wanted to tell you all you guys having electrical issues to just go ahead and replace your battery with a quality one first (not an o'reilly brand) like an optima or ac delco. The reason I say to is because I've went through a ton of batteries (used to flip cars) that tested out ok but were not ok. Just my opinion.
__________________
DSS FX Forged Pistons, Eagle ESP L19 Forged Rods, ARP Head and Main Studs, TSP PRC 260 CNC Ported Heads milled .030, Cometic .040 Head Gaskets, GPI SS3 VVT Camshaft, GM Performance Racing Lifters, CHE Trunnions , Molly Pushrods, Melling 10355HV Oil Pump, Cold Air Inductions CAI, Fast LSXR Intake Manifold, Nick Williams 103 TB, TSP 1 7/8" Longtubes with 3" TSP Exhaust, ZL1 Fuel Pump, Mishimoto Radiator, Mishimoto Oil Cooler, Tru Cool 40k Tranny Cooler, 3600 Circle D Converter, Fluid Dynamics Balancer
Build Thread https://www.camaro5.com/forums/showthread.php?t=609817 |
11-15-2022, 11:27 AM | #27 |
Drives: 2011 Camaro 2SS/RS Join Date: Oct 2013
Location: San Jose, California
Posts: 1,371
|
I know this is an old topic, but I'd thought I'd share.......
I had the same issue with my 2011 SS for several years. I'd think I figured it out, but it would quickly come back. Replaced the battery, battery cables, added grounds, cleaned all the grounds even replaced the camshaft and crank position sensors. None of it permanently fixed the issue. It would start with no issues three for four times but would have the same issues again. Finally, in July, I replaced the entire engine/transmission wiring harness. After plugging in the last connector and reconnecting the battery, the car fired right up. And has every single time since July. When it was having its issues, I didn't enjoy driving it. It would sit in the garage for months at a time. Was always afraid it would leave me stranded somewhere. It nice having my Camaro back.
__________________
|
11-15-2022, 02:17 PM | #28 | |
|
Quote:
__________________
|
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Viper 5901 Car Alarm/Remote Start review | =Stephens= | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 3 | 03-05-2011 06:07 PM |
My LLT engine is blown on my 2LT, any recommendations? | Camarodriver | 5th Gen Camaro SS LS LT General Discussions | 173 | 12-17-2010 06:17 AM |
My LLT is BLOWN! Connecting rod is loose... | Camarodriver | Camaro V6 LLT Engine, Exhaust, and Bolt-Ons | 158 | 12-05-2010 01:43 PM |
Pedders Suspension Benchmark Track Testing and New Jersey Track Day | Info@PeddersUSA.com | USA - NY / NJ / PA | 35 | 10-26-2009 05:20 PM |