Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Engine | Drivetrain | Powertrain Technical Discussions > Forced Induction - V8


Reply
 
Thread Tools
Old 01-20-2011, 01:41 PM   #953
redZ28
 
Drives: 2013 ZL1 Conv.
Join Date: Jan 2009
Location: Texas
Posts: 131
Quote:
Originally Posted by PQ View Post
I hope I didn't fry my ECU somehow. I had to interupt a transfer once. If it were bad I'd assume it would not transfer now but ya never know.
After I installed my Maggie, I drove it for 30 miles to Hennessey on the stock tune, and it drove normally. I never stomped the gas pedal, but I did drive it 70mph down the interstate. Therefore, your car should be able to run fine on the stock tune. I'll put my $1 bet on the ECU....but am hoping for a loose wire.
redZ28 is offline   Reply With Quote
Old 01-20-2011, 01:54 PM   #954
PQ
Booooosted.
 
PQ's Avatar
 
Drives: 2010 Supercharged SS
Join Date: Apr 2008
Location: Mobile, AL
Posts: 36,806
Send a message via Yahoo to PQ
Quote:
Originally Posted by redZ28 View Post
After I installed my Maggie, I drove it for 30 miles to Hennessey on the stock tune, and it drove normally. I never stomped the gas pedal, but I did drive it 70mph down the interstate. Therefore, your car should be able to run fine on the stock tune. I'll put my $1 bet on the ECU....but am hoping for a loose wire.
What was your set-up. Was it similar to mine?

No cats, Long tubes, full exhaust, wide open intake?
__________________
PQ is offline   Reply With Quote
Old 01-20-2011, 03:53 PM   #955
redZ28
 
Drives: 2013 ZL1 Conv.
Join Date: Jan 2009
Location: Texas
Posts: 131
Quote:
Originally Posted by PQ View Post
What was your set-up. Was it similar to mine?

No cats, Long tubes, full exhaust, wide open intake?
No, I had no extras at that time, just the Maggie with a 3.6 pulley.
redZ28 is offline   Reply With Quote
Old 01-20-2011, 03:59 PM   #956
BlownSS

 
BlownSS's Avatar
 
Drives: 2010 Camaro SS/RS
Join Date: Oct 2009
Location: Lincoln Nebraska
Posts: 1,758
pq....if i send you a copy of my tune....will that work for you to try?
__________________
2010 IOM SS/RS LS3, Hennessey HPE550 Polished Magnuson TVS2300 Supercharger. 3.4 Pulley. Kooks long tube headers / high flow cats. GHL Full exhaust. ZL1 Fuel Pump/ADM FPCM. MSW Bap. JRE ZL1 Race cam with new springs/pushrods/Trunion Upgrade. FIC 850cc injectors. ZR1 Map sensor. CAI Induction. JRE Tune.
BlownSS is offline   Reply With Quote
Old 01-20-2011, 04:02 PM   #957
PQ
Booooosted.
 
PQ's Avatar
 
Drives: 2010 Supercharged SS
Join Date: Apr 2008
Location: Mobile, AL
Posts: 36,806
Send a message via Yahoo to PQ
Quote:
Originally Posted by redZ28 View Post
No, I had no extras at that time, just the Maggie with a 3.6 pulley.
Sweet.
__________________
PQ is offline   Reply With Quote
Old 01-20-2011, 04:03 PM   #958
GTAHVIT
Blessed
 
GTAHVIT's Avatar
 
Drives: 2013 Sonic RS MT
Join Date: Dec 2007
Location: Saint Augustine FL
Posts: 28,510
Quote:
Originally Posted by BlownSS View Post
pq....if i send you a copy of my tune....will that work for you to try?
that may be worth a try....


Interesting.
GTAHVIT is offline   Reply With Quote
Old 01-20-2011, 04:04 PM   #959
BlownSS

 
BlownSS's Avatar
 
Drives: 2010 Camaro SS/RS
Join Date: Oct 2009
Location: Lincoln Nebraska
Posts: 1,758
it is a program from a renowned tuner.......it was basically uploaded to my predator tuner and then to the car. I kept a copy of the file here on my desktop.

Does anybody in his area have a predator to help him out with this?

I have the headers and high flow cats......6 speed....maggie with 3.6 pulley and CAI intake........ Kinda similar to what you have?
__________________
2010 IOM SS/RS LS3, Hennessey HPE550 Polished Magnuson TVS2300 Supercharger. 3.4 Pulley. Kooks long tube headers / high flow cats. GHL Full exhaust. ZL1 Fuel Pump/ADM FPCM. MSW Bap. JRE ZL1 Race cam with new springs/pushrods/Trunion Upgrade. FIC 850cc injectors. ZR1 Map sensor. CAI Induction. JRE Tune.
BlownSS is offline   Reply With Quote
Old 01-20-2011, 04:10 PM   #960
PQ
Booooosted.
 
PQ's Avatar
 
Drives: 2010 Supercharged SS
Join Date: Apr 2008
Location: Mobile, AL
Posts: 36,806
Send a message via Yahoo to PQ
Mine is an auto tranny. :(
__________________
PQ is offline   Reply With Quote
Old 01-20-2011, 04:12 PM   #961
BlownSS

 
BlownSS's Avatar
 
Drives: 2010 Camaro SS/RS
Join Date: Oct 2009
Location: Lincoln Nebraska
Posts: 1,758
ahhhh...one would think. But....i got my tunes via email order from him. It has been checked by a local tuner and there were no changes that he would make to it. Anyways.....since I got them from him and then had to load them to the tuner, I have the file on my desktop and in my car!!!!! This allows me to take my tune anywhere anytime. I am not tied to the original tuner!
__________________
2010 IOM SS/RS LS3, Hennessey HPE550 Polished Magnuson TVS2300 Supercharger. 3.4 Pulley. Kooks long tube headers / high flow cats. GHL Full exhaust. ZL1 Fuel Pump/ADM FPCM. MSW Bap. JRE ZL1 Race cam with new springs/pushrods/Trunion Upgrade. FIC 850cc injectors. ZR1 Map sensor. CAI Induction. JRE Tune.
BlownSS is offline   Reply With Quote
Old 01-20-2011, 04:13 PM   #962
BlownSS

 
BlownSS's Avatar
 
Drives: 2010 Camaro SS/RS
Join Date: Oct 2009
Location: Lincoln Nebraska
Posts: 1,758
ha ha you said Tranny! This may not work for you then.
__________________
2010 IOM SS/RS LS3, Hennessey HPE550 Polished Magnuson TVS2300 Supercharger. 3.4 Pulley. Kooks long tube headers / high flow cats. GHL Full exhaust. ZL1 Fuel Pump/ADM FPCM. MSW Bap. JRE ZL1 Race cam with new springs/pushrods/Trunion Upgrade. FIC 850cc injectors. ZR1 Map sensor. CAI Induction. JRE Tune.
BlownSS is offline   Reply With Quote
Old 01-20-2011, 04:15 PM   #963
Milk 1027
Camaro➎ moderator
 
Milk 1027's Avatar
 
Drives: '13 BLK 1LE
Join Date: Aug 2008
Location: AZ
Posts: 13,569
Worth a shot, IMO
__________________
Milk 1027 is offline   Reply With Quote
Old 01-20-2011, 04:17 PM   #964
zebra
just can't seem to leave
 
zebra's Avatar
 
Drives: your mom wild!!
Join Date: Oct 2008
Location: hot & windy
Posts: 10,601
it'll at least idle... unless it's looking for a clutch position switch to start the engine
__________________
zebra is offline   Reply With Quote
Old 01-20-2011, 04:19 PM   #965
GTAHVIT
Blessed
 
GTAHVIT's Avatar
 
Drives: 2013 Sonic RS MT
Join Date: Dec 2007
Location: Saint Augustine FL
Posts: 28,510
hrmph


Jax it is...
GTAHVIT is offline   Reply With Quote
Old 01-20-2011, 04:22 PM   #966
PQ
Booooosted.
 
PQ's Avatar
 
Drives: 2010 Supercharged SS
Join Date: Apr 2008
Location: Mobile, AL
Posts: 36,806
Send a message via Yahoo to PQ
Quote:
Originally Posted by BlownSS View Post
ha ha you said Tranny! This may not work for you then.
Might.

pq@althri.com



I won't use the tune but to only see if it helps. I"m dynoing it anyway, but it would be nice to know.

Quote:
Originally Posted by zebra View Post
it'll at least idle... unless it's looking for a clutch position switch to start the engine
?

Quote:
Originally Posted by Milk 1027 View Post
Worth a shot, IMO
??

Quote:
Originally Posted by GTAHVIT View Post
hrmph


Jax it is...
Either way............ ROOOOOOAAAAAAD TRIIIIIIIIIP............................
__________________
PQ is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Where to get engine cover modified after a Maggie install? 1meanss Cosmetics and Lighting Modification Discussions 5 03-05-2011 10:00 PM
Another Maggie install .... Luvpilot Forced Induction - V8 9 06-20-2010 10:00 PM
maggie install, hose routing suggestions please n2oSS Forced Induction - V8 6 05-31-2010 04:59 PM
DIY : Install catback on 2010 Camaro SS Nine Ball Camaro DIY & HOW-TO instructions & discussions 3 08-09-2009 05:36 PM


All times are GMT -5. The time now is 01:49 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.