Speedbleeder tick vs monster - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

bottletalk · 10-31-2020, 08:11 AM

shortly I'm gonna swap my stock clutch to my new lt1-s, question i have is there a difference between the tick and monster speedbleeders?
also swapping the plastic bearing support with the monster billet upgrade and figure that since I'll have everything out I'm gonna swap my slave too. Should I go with the monster slave or stick with stock?

camguynj · 10-31-2020, 09:35 AM

fyi...you can order a Monster slave and have them pre-install their Billet Release Bearing Support http://monsterclutches.com/gen-5-cam...slave-cylinder

OR

NEW from Tilton... self adjusting throw out bearing with braided SS lines with adapters for Camaro Tremec6060. The braided SS bleed line eliminates the need for a separate remote bleed line!

https://www.tickperformance.com/tilt...owout-bearing/

No plastic anywhere!

bottletalk · 10-31-2020, 09:57 PM

heard too many horror stories from hydraulic throughout bearings, of course more people share bad stories then good so I’m on the fence......don’t mind being a guinea pig but for something like pulling out the trans again for a leak doesn’t sound appealing. many people here running them? any info on clutch feel improvement?

back to the monster vs tick parts, is there really much of a difference?

ps: thanks for the info!

10-31-2020, 08:11 AM	#1
bottletalk Drives: 15 Camaro SS/RS Join Date: Jan 2020 Location: BC Posts: 265	Speedbleeder tick vs monster shortly I'm gonna swap my stock clutch to my new lt1-s, question i have is there a difference between the tick and monster speedbleeders? also swapping the plastic bearing support with the monster billet upgrade and figure that since I'll have everything out I'm gonna swap my slave too. Should I go with the monster slave or stick with stock?

10-31-2020, 09:35 AM	#2
camguynj Drives: '13 SS/RS LS3 NPP BRM Join Date: Jan 2013 Location: NJ Posts: 3,208 View My Garage	fyi...you can order a Monster slave and have them pre-install their Billet Release Bearing Support http://monsterclutches.com/gen-5-cam...slave-cylinder OR NEW from Tilton... self adjusting throw out bearing with braided SS lines with adapters for Camaro Tremec6060. The braided SS bleed line eliminates the need for a separate remote bleed line! https://www.tickperformance.com/tilt...owout-bearing/ No plastic anywhere! Last edited by camguynj; 10-31-2020 at 10:44 AM.

10-31-2020, 09:57 PM	#3
bottletalk Drives: 15 Camaro SS/RS Join Date: Jan 2020 Location: BC Posts: 265	heard too many horror stories from hydraulic throughout bearings, of course more people share bad stories then good so I’m on the fence......don’t mind being a guinea pig but for something like pulling out the trans again for a leak doesn’t sound appealing. many people here running them? any info on clutch feel improvement? back to the monster vs tick parts, is there really much of a difference? ps: thanks for the info!