Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > General Camaro Forums > Regional Forums > USA - Southeast


Reply
 
Thread Tools
Old 04-04-2010, 03:22 PM   #1
RJT-Maro
Emerald Coast Camaros
 
RJT-Maro's Avatar
 
Drives: 2010 Supercharged RJT SS!
Join Date: Jun 2009
Location: Eufaula, Alabama
Posts: 2,765
Send a message via AIM to RJT-Maro
Alabama Meet Up for Camaro5 Fest.

This is what I was thinking for all you Alabama folks.

Some of you will come through Eufaula(That's where I am). So I was thinking maybe we could meet somehwere here(will post at the bottom of this post) then head over to Valdosta.

If you are going to be coming through Eufaula on the way over there we could meet at the Winn Dixie Parking lot here?

It's going to take almost 3 hours to get there from here, and it's 2-lane all the way to Tifton, then that's where we will hit I-75, and that's 4-lane.


ALL TIMES BELOW ARE CST

Friday Morning

LOCATION A: Winn-Dixie Parking lot Eufaula, AL. Meet up between 9:30-9:45A.M. As soon as we get everyone acounted for we will depart. We need to leave no later than 10:15 A.M.

LOCATION B: Tifton, GA. We should arrive there by about 12:15 P.M. There is a BP Gas station and some others right here(this is the exit we will be usuing to get on I-75). I know everybody will not need gas but some may want to get a little snack for the remaining drive. We will spend about 30 minutes here. We need to depart from here no later than 1:00 P.M.
LOCATION C: Exit 16 in Valdosta. We should arrive here around 1:45 P.M. This exit is right where the road is that goes to the host hotel. (The rest of you that aren't in the host hotel I will have directions for you at the meet, just let me know if you need them.)

Again the times above are in CST. So acctually that puts us there by 2:45 P.M EST. Which is right before Hotel Check In.

So if you are coming thru Eufaula please post here so I can get a head count of whose going.

The picture below is the way we will be going. This is the fastest way I know.

I will send out a PM sometime this week to everybody in the group, to just give you a reminder, and send you the Schedule one more time so you will not forget.

The key to this is to stay on time.
Thanks,
RJT

This is the original thread this came from(by me) http://www.camaro5.com/forums/showthread.php?t=75185

So just post here if you are going to join us and I will add you to the list.

Thanks
Attached Images
 
__________________
2010 Camaro SS LS3 Supercharged RJT!
Magnuson TVS 2300 Supercharger, ARH 1 7/8 LT Headers with 3" X-Pipe, Borla S-Type Axle-Back, DMH Low Profile Exhaust Cut-Outs, MTI Racing CAI, Stage 2 Camshaft(227/239 .614/.624) with new springs, Katech C5R Z Timing Chain, LS7 Bowtie Damper, MTI Hot Spark Plug Wires, MTI Racing Lowering Springs and Swaybars, Aluminum Oil Catch Can, 160 Degree Thermostat, MTI Tune. 554RWHP 528RWTQ Built By: MTI Racing Dyno Sheet here

Last edited by RJT-Maro; 04-04-2010 at 08:03 PM.
RJT-Maro is offline   Reply With Quote
Old 04-04-2010, 08:03 PM   #2
RJT-Maro
Emerald Coast Camaros
 
RJT-Maro's Avatar
 
Drives: 2010 Supercharged RJT SS!
Join Date: Jun 2009
Location: Eufaula, Alabama
Posts: 2,765
Send a message via AIM to RJT-Maro
For the Time change in Post #1
__________________
2010 Camaro SS LS3 Supercharged RJT!
Magnuson TVS 2300 Supercharger, ARH 1 7/8 LT Headers with 3" X-Pipe, Borla S-Type Axle-Back, DMH Low Profile Exhaust Cut-Outs, MTI Racing CAI, Stage 2 Camshaft(227/239 .614/.624) with new springs, Katech C5R Z Timing Chain, LS7 Bowtie Damper, MTI Hot Spark Plug Wires, MTI Racing Lowering Springs and Swaybars, Aluminum Oil Catch Can, 160 Degree Thermostat, MTI Tune. 554RWHP 528RWTQ Built By: MTI Racing Dyno Sheet here
RJT-Maro is offline   Reply With Quote
Old 04-07-2010, 07:26 PM   #3
RJT-Maro
Emerald Coast Camaros
 
RJT-Maro's Avatar
 
Drives: 2010 Supercharged RJT SS!
Join Date: Jun 2009
Location: Eufaula, Alabama
Posts: 2,765
Send a message via AIM to RJT-Maro
__________________
2010 Camaro SS LS3 Supercharged RJT!
Magnuson TVS 2300 Supercharger, ARH 1 7/8 LT Headers with 3" X-Pipe, Borla S-Type Axle-Back, DMH Low Profile Exhaust Cut-Outs, MTI Racing CAI, Stage 2 Camshaft(227/239 .614/.624) with new springs, Katech C5R Z Timing Chain, LS7 Bowtie Damper, MTI Hot Spark Plug Wires, MTI Racing Lowering Springs and Swaybars, Aluminum Oil Catch Can, 160 Degree Thermostat, MTI Tune. 554RWHP 528RWTQ Built By: MTI Racing Dyno Sheet here
RJT-Maro is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
The Official Pfadt Camaro5 Fest car show/burn out competition thread! PfadtRacing 2010 Camaro5 Fest (I) 57 04-12-2010 08:09 PM
Camaro5 Fest Alabama meet up... RJT-Maro 2010 Camaro5 Fest (I) 11 03-28-2010 03:29 PM
East Tennessee 5th Generation 2nd meet 304hp? USA - Southeast 0 03-23-2010 08:42 PM
C5G End of the Season Meet Nov. 8 Black5thgen USA - Great Lakes 8 11-06-2009 09:11 PM
Michigan FBody Meet & Greet, May 30th, Milford Michigan meissen USA - Great Lakes 23 05-30-2009 10:24 PM


All times are GMT -5. The time now is 11:33 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.