06-17-2017, 11:00 AM | #1 |
Drives: Black 2013 ZL-1 Join Date: Jun 2017
Location: Byers,Colorado
Posts: 13
|
body panels misaligned
hey,,! anyone suggest a cure for what i can only describe as a a sunken inward exterior door panel joint? ..unsightly 3/16 gap that seems to start just around the middle horizontal door crease and runs the length of the entire bottom of door.. passenger side.
|
06-19-2017, 01:04 AM | #2 |
"BEASTM*DE"
|
You may be able to adjust the inner door joints...If all else fails I'm sure a body shop can get that lined back up...
__________________
Vengeance Racing Stage 1 Kit 575rwhp, 569 rwtq...
Rims powder coated gloss black...BFG'S Comp 2 A/S... Dual 10" Kicker Comp S Subs 1200w... |
06-19-2017, 06:12 AM | #3 |
Drives: 2011 ss Join Date: May 2013
Location: va
Posts: 983
|
Door needs adjusting to close that gap. The bolts on the door hinges are how to fix it
|
06-19-2017, 07:35 AM | #4 |
Drives: 2002 Camaro SS SOM; 2015 Malibu LTZ Join Date: Dec 2010
Location: Queens, NY
Posts: 4,022
|
Typical GM workmanship. Before I would adjust anything, check to see if there are signs of misalignment, such as scuffs, excessive wear on the door striker, non seal of window and doors (if you get excessive wind noise or drafts). In general I do not have body joints adjusted unless its a glaring issue (very noticeable and unsightly). If you are still under warranty then I'd have the dealer handle it; Otherwise look for a top quality body shop to take care of the issue.
__________________
'02 CAMARO SS SOM; 5.7L LS1/FLS6B
'08 TBSS AWD Black Granite Metallic '15 Malibu LTZ 2LZ Turbo '14 CAMARO ZL1 Blue Ray Metallic |
06-19-2017, 08:07 AM | #5 |
Drives: 02 Z06, 95 Trans Am, 2012 ZL1 Join Date: Mar 2012
Location: Southeast
Posts: 1,838
|
Did someone put it on a lift and squash the pinch weld underneath? That would cause the fender to bulge out. Check underneath for damage.
__________________
Bryan 2018 ZL1 M6
|
06-21-2017, 03:48 PM | #6 |
Drives: 2013 ZL1 VERT M6 Join Date: May 2013
Location: Portland, Maine
Posts: 346
|
Fender and Door
I agree.
If under warranty just take it in. Otherwise take it into a body shop. If you feel confident enough you can adjust the door and the fender. Get someone to help you as the door is heavy. This is done in the hinges on the door, there is not a lot of room, but maybe enough to take up this slack. If you loosen the fender bolts you can move the fender in and out too.
__________________
JANNETTY RACING 750 ROUGH IDLE CAM PACKAGE
(681 RWHP & 643 RWTQ) = 783 CRANK HP & 740 CRANK TQ |
|
|
|
|