07-04-2018, 03:01 PM | #1 |
Drives: 2015 Black rs/ss/1le Join Date: Apr 2018
Location: PA
Posts: 271
|
clean side oil catch can question
I am replacing the "clean" side oil catch can with a regular oil cap.
Would anyone happen to know what happens to the hole at the other end attached to the intake tube when I remove the plastic oil line? See the green circle in this picture.... https://imgur.com/i9OBBck This is a used car so I'm not sure what parts were taken off. Thanks! |
07-04-2018, 03:38 PM | #2 |
Valve cover line
If I remember correctly, the port on passenger valve cover attaches there. It is under the engine cover. Have to remove it and should be right above the oil fill tube there next to intake. It should plug into that fitting once you remove the separator.
Stole this off Google, but it shows how it should be, minus the CAI, but same concept. |
|
07-04-2018, 08:38 PM | #3 | |
Drives: 2015 Black rs/ss/1le Join Date: Apr 2018
Location: PA
Posts: 271
|
Quote:
|
|
07-05-2018, 11:53 AM | #4 |
Good deal. Hope that got you squared away.
|
|
07-07-2018, 10:01 PM | #5 |
Drives: 2014 2SS/RS Join Date: Dec 2014
Location: Raleigh, NC
Posts: 1,053
|
Hopefully previous owner left the original vent line in the car trunk or in the white rectangular cardboard box that use to contain the separator; that the factory throws in the trunk (separator is dealer or owner installed after delivery) .
If the original 1LE factory supplied separator was installed per instructions (shown below), a rubber sealed nipple cap "B" should be in place on the fitting near oil filler neck ... follow the jagged line from part "B" and it shows location. One end of the original LS3 vent hose connects to that nipple when the separator is removed and the other end plugs onto the fitting in Figure "8" below located on the plastic air intake tube housing.
__________________
2014 2SS/RS, Z28 CAI and High Wing Spoiler, ZL1 5.1:1 Ratio Short-Throw Shifter, ZL1 Pedals, ZL1 splash guards, NPP Dual-mode quad tip exhaust, Z28 strut tower brace, Camaro LED Cup-holders with footwell Lighting option, Leather visors, and Leather E-brake boot. Chevy dealer sponsored 67 retro SS nose stripe package.
Last edited by ron123; 07-07-2018 at 10:15 PM. |
07-20-2018, 10:07 PM | #6 |
Drives: 2015 Black rs/ss/1le Join Date: Apr 2018
Location: PA
Posts: 271
|
|
07-20-2018, 10:16 PM | #7 | |
Drives: 2015 Black rs/ss/1le Join Date: Apr 2018
Location: PA
Posts: 271
|
Quote:
Thanks for your help. |
|
|
|
|
|