06-10-2013, 02:54 PM | #1 |
Drives: Anything I want Join Date: Oct 2008
Location: DfW - Texas
Posts: 5,405
|
ADM PERFORMANCE Wireless Exhaust Valve Control thread
Here is were we would like those who ordered our first batch of exhaust controllers to post about the new Wireless ADM Exhaust Valve controller for ZL1 AND ALL FACTORY EQUIPPED NPP CAMAROS.
Here is the preliminary written instructions,please be advised they will be updated based on feedback and future changes if any. All work is done in the trunk. Removal: Remove rear cargo Carpet. Remove black rear trim panel . Fold back passenger side rear carpet to access fuse block and new mounting point for controller Unplug small 2 pin connector/harness that goes through the floor. Push harness and grommet through the floor exposing it on the other side. Unplug 2 pin connector at flapper solenoid (above passenger side muffler behind tire)by squeezing hard on metal wires on each side and pulling abruptly. See pic Install new harness in reverse order. Install: Once you have the new harness installed with grommet properly secured in place and connectors properly plugged in you can now install the ADM CONTROLLER Install velcro in proper location to mount control box.See pic Remove fuse block cover. Plug new white connectors together from ADM CONTROLLER TO HARNESS YOU JUST INSTALLED(Only plugs in1 way) Install nut plate clip were hole is just below factory ground. Install supplied bolt through relay and bolt to nut plate.(Use 10mm socket) Remove factory ground bolt and install ground bolt through eyelet in wiring harness.Tighten to 90 inch pounds with 10mm socket You are required to solder and heat shrink of tap into the pink wire on the back side of the fuse block for power.The red wire is power from the adm controller. NOTE - THE BLUE WIRE IS THE ANTENNA,A SUPPLIED TYE WRAP CAN TIE IT UP IF NECESSARY Last edited by ADM PERFORMANCE; 03-16-2015 at 06:57 AM. |
06-11-2013, 10:52 AM | #2 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
Thanks Andy!
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
06-11-2013, 11:41 AM | #3 |
How does the controller work, a wireless key chain controller, through the homelink buttons ? How does it differ from the "Mild to Wild" switch?
|
|
06-11-2013, 11:45 AM | #4 |
Drives: 2016 SS, BLACK, MANUAL Join Date: Apr 2010
Location: pittsburgh, pa
Posts: 277
|
Andy, do you have an ETA yet for delivery???? The neighbors are getting restless!!
__________________
2016 Black/Black SS, 6speed, MRC, Roto-Fab air intake, Vitesse controller,
1 7/8" headers and exhaust from Stainless Works complete with nonNPP mufflers and 5"outlets, Katech ported TB, Moroso catch can, MRR M017 polished powder wheels, Eibach lowering springs, and BMR upper/ lower trailing arms and upper control arms. ZL1/1le sway bars and Magnusson Supercharger with Jannetty tune. Stay Tuned!!!......More to come. 2014 Camaro Ashen grey, 3.6, 6 speed, Vararam intake, Elite catch can, chrome wheels, and Vitesse controller. 2003 SSR red, 2016 Vette |
06-11-2013, 01:22 PM | #5 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
UPS tracking says mine should be here on Friday!!
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
06-11-2013, 01:58 PM | #6 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
"closed" or "stock" operation for this ADM unit which is unlike anything on the market. Mild to wild can only go to "open" or "stock"
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
06-11-2013, 06:42 PM | #7 |
Drives: Anything I want Join Date: Oct 2008
Location: DfW - Texas
Posts: 5,405
|
|
06-11-2013, 07:11 PM | #8 |
Drives: 2017 ZL1, 2015 Z51 vette 2005 gto Join Date: Sep 2009
Location: New Castle,pa
Posts: 252
|
Any chance of this being closed,stock,and open?? And can you pm me a price?
__________________
|
06-11-2013, 07:20 PM | #9 |
Drives: 2013 Triple Black ZL1 / 2006 TB SS Join Date: Feb 2011
Location: MN
Posts: 2,250
|
No kidding. I swear it's louder with headers on start up compared my old 98 TA which had a stroker motor with a big cam and high compression.
I should have mine tomorrow so I will make sure to report back. This kit should sell pretty well as more owners with dual mode exhaust modify their cars. IMO this is the hot exhaust set up for these cars. Best of both worlds. |
06-12-2013, 07:38 AM | #10 |
Drives: Anything I want Join Date: Oct 2008
Location: DfW - Texas
Posts: 5,405
|
|
06-12-2013, 07:56 AM | #11 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
I think some people like their ear drums to bleed! Or "there can never be too much sound!!"
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
06-12-2013, 08:52 AM | #12 |
Drives: '05 OB Neon SRT4, '13 IOM ZL1 Join Date: Sep 2012
Location: North Jersey
Posts: 106
|
|
06-12-2013, 01:38 PM | #13 |
Drives: 2013 ZL1 Join Date: Oct 2011
Location: tangent or
Posts: 2,984
|
Hey Andy did you sell all of the first ten kits?
__________________
shopping for 2017+1le or zl1
2009 CTS-V -sold 2015 Hellcat-sold 2013 ZL1 -sold 2007 Z06- sold 2014 Chrysler 300 2011 Duramax 8" lift, deleted tuned |
06-12-2013, 01:55 PM | #14 |
Drives: 2016 SS, BLACK, MANUAL Join Date: Apr 2010
Location: pittsburgh, pa
Posts: 277
|
Mine too!! Thanks Andy!!
__________________
2016 Black/Black SS, 6speed, MRC, Roto-Fab air intake, Vitesse controller,
1 7/8" headers and exhaust from Stainless Works complete with nonNPP mufflers and 5"outlets, Katech ported TB, Moroso catch can, MRR M017 polished powder wheels, Eibach lowering springs, and BMR upper/ lower trailing arms and upper control arms. ZL1/1le sway bars and Magnusson Supercharger with Jannetty tune. Stay Tuned!!!......More to come. 2014 Camaro Ashen grey, 3.6, 6 speed, Vararam intake, Elite catch can, chrome wheels, and Vitesse controller. 2003 SSR red, 2016 Vette |
|
|
|
|