10-30-2016, 12:33 PM | #1 |
Drives: Camaro Join Date: Mar 2009
Location: Oshawa
Posts: 126
|
2010 v6 "Pwr reduced service stabilitrack!" Throttle body?
I've read quite a few threads and am wondering if the consensus with this problem and reduced power is a known throttle body issue? Others have found loose wires and plugs to be the culprit. 40,000miles only.
I swapped out my throttle body for the vmax in May. I have reached out. My mechanics had a look but can't figure it out. Reduced poweer and alomost stall on takeoff. Any links appreciated Mark/Oshawa |
10-30-2016, 11:07 PM | #2 |
having FUN now 13.66@101
|
Did you try unhooking the battery in the trunk over night, to force a relearn from the computer with your throttle body. Try that first. I remember there was some other things to try too, but will need to look them up in the 3 book manual. Did it trip a code? if so what was the code number too.
__________________
|
10-31-2016, 12:43 PM | #3 |
Built Not Bought
Drives: 2010 Twin Turbo LFX Join Date: Jun 2016
Location: Massachusetts
Posts: 618
|
when i was having the same issue it was caused by a misfiring issue..
__________________
2010 Twin Turbo LFX
In Memory of my DAD Gone but never Forgotten 2014 "Built Not Bought!' Sponsors: OverKill Motorsports |
11-01-2016, 12:16 PM | #4 |
Drives: 2010 2LT Bumblebee Join Date: Apr 2013
Location: Maryland
Posts: 613
|
I had this problem for literally a year, could be a number of things, in the end for me it was misfiring due to a spun bearing. But until then I checked the battery wires, the battery itself, removed my Vitesse Throttle Controller, etc. But I actually never went back to my stock throttle body, because I had my Vmax on for a couple years before having this problem. So ya check/remove all those things and work from there.
__________________
AirLift Air Suspension, Stainless Works Long Tube Headers + Hi-Flo Cats, Resonated X-Pipe, MRT V2 Mufflers, VMAX Ice-olator and Ported Throttle Body, Barton Short Throw Shifter, CAI Intake + Air Scoop
|
11-01-2016, 10:27 PM | #5 |
|
Mass air flow sensor probably. Clean it with mass air flow sensor cleaner.
__________________
MODS 6.0 forged iron block, TH400, B&M shifter, DSS axles & driveshaft, Viking / BMR suspension, Full custom fuel system with cell, Twin 76mm teriyaki tornados on 24lbs.
https://www.instagram.com/whoopa_ss/ |
11-02-2016, 08:43 AM | #6 |
Drives: 2017 SS 1LE Join Date: Jun 2011
Location: Akron OH
Posts: 293
|
|
11-04-2016, 09:26 PM | #7 |
|
That too but cleaning is a cheaper alternative. If it works you save money if not you're out $5.
__________________
MODS 6.0 forged iron block, TH400, B&M shifter, DSS axles & driveshaft, Viking / BMR suspension, Full custom fuel system with cell, Twin 76mm teriyaki tornados on 24lbs.
https://www.instagram.com/whoopa_ss/ |
|
|
|
|