12-12-2013, 02:36 PM | #1 |
|
Torq Specs + Wrenches
Anyone know what the torq specs are for the ZL1 Headers, cause i will be installing Kooks headers, and also what type of wrenches and torq needed for the O2 Sensors?
All these questions come to mind, because i will be installing new gaskets as well.
__________________
|
12-12-2013, 02:50 PM | #2 |
Jedi Master
Drives: Boeing 757/767+2010 IBM 2SS Join Date: Aug 2008
Location: Bangor, ME and Palm Coast, FL
Posts: 1,121
|
I normally tighten everything to 1/2 turn before breaking :-)
__________________
|
12-12-2013, 04:15 PM | #3 |
|
If I remember correctly.....the header bolts are 18 ft-lbs. I used anti-seize on mine. I also used a special O2 Sensor Socket on the sensors, but I didn't bother with any specific torque.....just good-n-tight. Re-check the header bolts after about 500 miles.
|
12-12-2013, 05:45 PM | #4 | |
|
Quote:
How many hands turns after its snug is that lol , i dont have a torque wrench just good ol hands.
__________________
|
|
|
|
|
|