12-29-2021, 01:40 PM | #1 |
Drives: 2012 2ss stick. Boosted 45th! Join Date: Oct 2020
Location: So Cal
Posts: 44
|
Catch Can routing with MP2300
TIA!!!!, could someone help me out with the catch can lines. I have ran them on non-boosted set-ups before, but now with the Maggie I'm thinking something is off. I have the Mishi can and as it is, the "in" is pulling from the pass side valve cover and the "vac" is connected to the intake tube, pre-TB.Is that correct? I'm reading drivers side PCV for the "in" and lower barb on the front of the MP2300 as the vac. I have a photo attached as is. The Blue vac line is currently from the PCV to the correct barb on the Maggie, as far as I know...
__________________
45th Anniversary.stick. Boosted!
|
12-29-2021, 01:59 PM | #2 |
Drives: 2010 Camaro SS Join Date: May 2018
Location: North Carolina
Posts: 29
|
You pull clean air (intake tube) through the Passenger side Valve Cover and then out the Driver Side/ Intake Valley to the catch can and then your post TB port. If you pull from the Valley, cap the Driver side valve cover.
|
|
|
|
|