06-21-2018, 06:32 AM | #1 |
Drives: camaro Join Date: Mar 2014
Location: United States
Posts: 2
|
Rear Quarter Window Seal
Passenger side rear quarter window seal is loose. Has anyone else had or noticed this problem or anyone have theirs leak ?
Last edited by 1badsscamaro2013; 06-21-2018 at 06:58 AM. |
06-24-2018, 04:16 PM | #2 |
376 cubic inches of fun
|
No, that's not how it's supposed to fit. (Just checked on my 2010.) Looks like aftermarket replacement junk. What's the history of your car?
|
06-25-2018, 04:43 AM | #3 |
Drives: camaro Join Date: Mar 2014
Location: United States
Posts: 2
|
2013 SS purchased new been garaged for winters noticed it this spring when got it out to wash up the other side fits tight I’ve seen where that seal is made with the window was just concerned if it leaking and creating rust problems ! Just posting to see if it was a common problem with the fifth Gen
|
06-25-2018, 06:04 AM | #4 |
376 cubic inches of fun
|
Mine is also garaged. The seal fits snug into the recess. I don't know how hard you're trying to lift it. It is flexible and not glued down, but there's no gap that would allow me to lift the edge. Obviously, I'm not going to try prying it up.
While the windshield is glued in, other windows may be retained by channelled rubber seals. Windshields used to be installed this way too, until they became structural members of the car body. The only instance I ever had of rust was due to a mis-shaped pinch weld that allowed water to leak into the channel in the seal, and down into the pinch weld where there was little or no paint. But we're talking 30 years ago, when forming and welding were crude by today's computer controlled standards. |
|
|
Thread Tools | |
|
|