Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Technical Camaro Topics > Dragstrip and Launch Techniques Discussion


Reply
 
Thread Tools
Old 08-12-2018, 02:40 AM   #1
SSGraybeard
 
SSGraybeard's Avatar
 
Drives: 2010 SS/RS M6
Join Date: Oct 2017
Location: Portland, Or
Posts: 24
Stoked

My 1st pass tonight (3rd overall since adding nitrous) 12.500@118.93...new personal best. funny thing is on my tech card I listed my "goal" as 12.5, what are the odds of adding two zero's behind the 5? lol
__________________
K & N CAI, Vmax PTB, Moroso CC, MSD Blaster Coils/8.5 MSD Plug Wires, Kooks LTH W/ HF Cats, Custom exhaust system W/ Noweeds Cutouts, Upgrade bushing kit for Hurst shifter, Hurst Line Lock, DSS Stage 4 Axles, DSS one piece CF Drive Shaft, Custom Built 1000 HP Clutch, BMR Drag Package/Toe Rods/Coil Over Conversion etc., BMR Extreme rear sway bar, BMR Sub frame connectors, BMR trans tunnel brace, BMR DS safety loop, Nitrous Outlet wet system W/100 shot, Nitto 315 DR's for strip, 315's for dd, Dyno tuned at 406rwhp/407rwtq N/A, 561/569 on Nitrous.
SSGraybeard is offline   Reply With Quote
Old 08-12-2018, 07:38 AM   #2
frankwjr


 
frankwjr's Avatar
 
Drives: 2010 SS 2SS M6
Join Date: Aug 2016
Location: Smithsburg, Md.
Posts: 2,446
nice run...post your time slip....sounds like your not getting out of the hole....whats the 60?


peace
__________________
2010 SS 2SS M6 - Tune by RDP dynoSteve!(Woot) - Daily Driver - 150K! - All work by me...
frankwjr is offline   Reply With Quote
Old 08-12-2018, 11:16 AM   #3
SSGraybeard
 
SSGraybeard's Avatar
 
Drives: 2010 SS/RS M6
Join Date: Oct 2017
Location: Portland, Or
Posts: 24
not sure how to get pics from phone to here...but you are correct my 60' sucks 2.269 was only my 3rd pass with nitrous so r/t 60' was not my main focus. I was pleasantly surprised with the et/trap speed. thing eats on the big end, chirped 3rd & 4th. next week will work on r/t 60' now that I know/trust how the car reacts when the nitrous hits.
__________________
K & N CAI, Vmax PTB, Moroso CC, MSD Blaster Coils/8.5 MSD Plug Wires, Kooks LTH W/ HF Cats, Custom exhaust system W/ Noweeds Cutouts, Upgrade bushing kit for Hurst shifter, Hurst Line Lock, DSS Stage 4 Axles, DSS one piece CF Drive Shaft, Custom Built 1000 HP Clutch, BMR Drag Package/Toe Rods/Coil Over Conversion etc., BMR Extreme rear sway bar, BMR Sub frame connectors, BMR trans tunnel brace, BMR DS safety loop, Nitrous Outlet wet system W/100 shot, Nitto 315 DR's for strip, 315's for dd, Dyno tuned at 406rwhp/407rwtq N/A, 561/569 on Nitrous.
SSGraybeard is offline   Reply With Quote
Old 08-13-2018, 07:53 AM   #4
KB85
Banned
 
Drives: Camaro
Join Date: Aug 2018
Location: Ohio
Posts: 54
I'm guessing you are running a 20" wheel? what tire pressure? you should be well into 11s
KB85 is offline   Reply With Quote
Old 08-13-2018, 04:36 PM   #5
SSGraybeard
 
SSGraybeard's Avatar
 
Drives: 2010 SS/RS M6
Join Date: Oct 2017
Location: Portland, Or
Posts: 24
Quote:
Originally Posted by KB85 View Post
I'm guessing you are running a 20" wheel? what tire pressure? you should be well into 11s
Yes running 20" 315 nitto dr's @ 15 psi. the BMR coilover conversion set up can be converted to a 15" setup which has a lot more tire options. That's for next year. I know the car is a lot faster, was not worrying about launch/60' etc just getting comfortable with the nitrous & all the rest of the changes to the car. But I agree, I will be upset if not running in the 11s by the end of this season.
__________________
K & N CAI, Vmax PTB, Moroso CC, MSD Blaster Coils/8.5 MSD Plug Wires, Kooks LTH W/ HF Cats, Custom exhaust system W/ Noweeds Cutouts, Upgrade bushing kit for Hurst shifter, Hurst Line Lock, DSS Stage 4 Axles, DSS one piece CF Drive Shaft, Custom Built 1000 HP Clutch, BMR Drag Package/Toe Rods/Coil Over Conversion etc., BMR Extreme rear sway bar, BMR Sub frame connectors, BMR trans tunnel brace, BMR DS safety loop, Nitrous Outlet wet system W/100 shot, Nitto 315 DR's for strip, 315's for dd, Dyno tuned at 406rwhp/407rwtq N/A, 561/569 on Nitrous.
SSGraybeard is offline   Reply With Quote
Old 08-16-2018, 05:40 PM   #6
bayarea408

 
bayarea408's Avatar
 
Drives: T
Join Date: Mar 2015
Location: CA
Posts: 803
there is TONS on your table left, 2.2 60 ft... is bad lol, but good cause you can go FASTER.
bayarea408 is offline   Reply With Quote
Old 08-18-2018, 02:20 AM   #7
SSGraybeard
 
SSGraybeard's Avatar
 
Drives: 2010 SS/RS M6
Join Date: Oct 2017
Location: Portland, Or
Posts: 24
Quote:
Originally Posted by bayarea408 View Post
there is TONS on your table left, 2.2 60 ft... is bad lol, but good cause you can go FASTER.
I know, I was a little hesitant to post that 60' time lol, its bad...but, nowhere to go but faster! but again I was not concerned w/ anything but testing nitrous/suspension changes...just did not know what to expect with the nitrous hit (on a wot switch), damn I hooked on the bottle lol
__________________
K & N CAI, Vmax PTB, Moroso CC, MSD Blaster Coils/8.5 MSD Plug Wires, Kooks LTH W/ HF Cats, Custom exhaust system W/ Noweeds Cutouts, Upgrade bushing kit for Hurst shifter, Hurst Line Lock, DSS Stage 4 Axles, DSS one piece CF Drive Shaft, Custom Built 1000 HP Clutch, BMR Drag Package/Toe Rods/Coil Over Conversion etc., BMR Extreme rear sway bar, BMR Sub frame connectors, BMR trans tunnel brace, BMR DS safety loop, Nitrous Outlet wet system W/100 shot, Nitto 315 DR's for strip, 315's for dd, Dyno tuned at 406rwhp/407rwtq N/A, 561/569 on Nitrous.
SSGraybeard is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:49 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.