02-04-2010, 10:51 AM | #1 |
Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 341
|
How to replace wiper blade arms on a 96 Z28
On my 1996 Camaro Z28 I need to replace the windshield wiper Arm. I have a 94 parts car sitting at a friends house and I can just pull the wiper arm off but that is where I run into the problem… These early 4th gen wiper blade arms are so hard (or I just don’t know how) to remove… I popped the housing, then unbolted it but like it seems the entire arm is screwed in and I dontk now how to get it out. Any ideas? If you guys have pictures that would be extremely helpful.
__________________
|
02-04-2010, 02:01 PM | #2 | ||
Truth Enforcer
Drives: anything I can get my hands on Join Date: Sep 2006
Location: anywhere and everywhere
Posts: 22,797
|
do you need to replace the entire arm or just the blade?
the arm itself is pressed onto a splined shaft. get some PB blaster and soak the shaft over night then come back and start on it again. they can be a PITA to remove. I cracked my windshield pulling mine, so be careful
__________________
Never race anything you can't afford to light on fire and push off a cliff
A group as a whole tends to be smarter than the smartest person in that group until one jackass convinces everyone otherwise. Quote:
Quote:
|
||
02-04-2010, 02:49 PM | #3 |
Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 341
|
yea the whole arm... wish it was simple like the blade
yea im gunna be careful :/ darn wish there was an easier way
__________________
|
02-05-2010, 03:16 PM | #4 | |||
Truth Enforcer
Drives: anything I can get my hands on Join Date: Sep 2006
Location: anywhere and everywhere
Posts: 22,797
|
Quote:
its a PITA. here's a diagram of the whole linkage when I went to pull mine off, it was because the drivers side blade didnt move with the pass side.... after cracking the windshield I found that the linkage that connects the left and right sides was popped off. so I basically cracked my windshield over nothing...
__________________
Never race anything you can't afford to light on fire and push off a cliff
A group as a whole tends to be smarter than the smartest person in that group until one jackass convinces everyone otherwise. Quote:
Quote:
|
|||
02-05-2010, 04:04 PM | #5 |
Drives: 2012 Chevrolet Camaro 2LS Join Date: Jan 2010
Location: Coral Springs, FL
Posts: 341
|
man sorry about your windshield....... thank you so much for this diagram though, its going to be a pain but i need to do it. the drivers side arm wont touch the window, so well when it rains i cant wipe that side so this should help me out alot
__________________
|
02-05-2010, 04:14 PM | #6 |
Drives: me up the wall. Join Date: Dec 2009
Location: Lakewood, CA
Posts: 471
|
|
02-05-2010, 04:16 PM | #7 |
Drives: me up the wall. Join Date: Dec 2009
Location: Lakewood, CA
Posts: 471
|
Oh, nevermind, I just realized the setup and that won't work.
Sorry! I'll butt out now. |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Do you want the Z28? | ChrisB | Camaro ZL1 Forum - ZL1 Specific Topics | 1616 | 09-04-2010 11:49 PM |
Think about this and the Z28 5th gen | 13F20 | Camaro ZL1 Forum - ZL1 Specific Topics | 41 | 09-04-2010 12:59 AM |
Why do you think the Z28 is the higher tier? | The_Blur | Camaro ZL1 Forum - ZL1 Specific Topics | 181 | 10-14-2009 08:08 PM |
Bob Lutz interview | radz28 | 5th Gen Camaro SS LS LT General Discussions | 113 | 08-28-2008 01:30 PM |
Z28 - Please try and understand..... | GTAHVIT | Camaro ZL1 Forum - ZL1 Specific Topics | 73 | 07-24-2008 12:30 PM |