08-29-2019, 11:39 AM | #1 |
Drives: 2013 VR ZL1, M6 Join Date: Nov 2017
Location: PA
Posts: 336
|
14-15' OEM Rear Splash Trim on a 12-13' ZL1
Hey guys, has anyone successfully retrofitted the 14-15' OEM rear splash trim on a 12-13' ZL1? I purchased them in the hopes they would bolt on, but it looks like I will need to replace my fender liners with liners from the 14-15' ZL1. I ask, because I like how they extend to the top of the rear fascia (see photo) vs stopping half way like they do on my 13' ZL1.
__________________
#3257 | 485whp 526wtq | K&N 63-3079 | Gates K080660HD (Green Belt) | ACDelco UPF48R | ZL1 Addons Wicker Bill | Mild2Wild
|
08-29-2019, 06:53 PM | #2 |
Drives: 2013 ZL1 Join Date: Mar 2013
Location: Oklahoma
Posts: 2,298
|
Alot of guys buy the 3M tape and clean the area where they fit with alcohol real good and they will stick with out any screws. I have used the bottom screws just to make sure it has something to help secure it.
|
08-30-2019, 08:30 AM | #3 |
Drives: 2013 VR ZL1, M6 Join Date: Nov 2017
Location: PA
Posts: 336
|
Thanks... I’ll give that a try.
__________________
#3257 | 485whp 526wtq | K&N 63-3079 | Gates K080660HD (Green Belt) | ACDelco UPF48R | ZL1 Addons Wicker Bill | Mild2Wild
|
09-16-2019, 12:18 PM | #4 |
Drives: 2013 ZL1 Join Date: Dec 2018
Location: Oklahoma
Posts: 1
|
Try Looking at this.
https://www.phastekperformance.com/p...uard-combo.htm |
09-17-2019, 11:37 AM | #5 | |
Drives: 2013 VR ZL1, M6 Join Date: Nov 2017
Location: PA
Posts: 336
|
Quote:
I'm going to contact phastek and see if these extend higher than the factory rear 2012-2013 ZL1 rock/splash guards.
__________________
#3257 | 485whp 526wtq | K&N 63-3079 | Gates K080660HD (Green Belt) | ACDelco UPF48R | ZL1 Addons Wicker Bill | Mild2Wild
|
|
|
|
|
|