04-11-2020, 09:39 PM | #1 |
Drives: 2014 1le 1SS CRMT Join Date: Apr 2014
Location: Boston mass
Posts: 1,178
|
Suspension bolts ?
I am getting ready to do the front & rear suspension on my 2014 1le I’m doing all polyurethane BMR suspension do I need all new bolts or can I reuse the old ones?
|
04-12-2020, 10:49 AM | #2 |
Drives: G8 Join Date: Mar 2012
Location: NJ
Posts: 251
|
I have removed pretty much all the suspension bolts and reused them. I'm pretty sure 99% of us do the same
Sent from my Pixel 4 XL using Tapatalk |
04-12-2020, 12:39 PM | #3 |
Drives: 2014 1le 1SS CRMT Join Date: Apr 2014
Location: Boston mass
Posts: 1,178
|
OK thanks for the heads up
|
04-12-2020, 10:01 PM | #4 |
Drives: 2011 Camaro 2LT Join Date: Oct 2018
Location: Az
Posts: 367
|
There’s a lot of heated discussion on this forum about reusing the torque to yield (TTY) suspension bolts. If you choose to reuse, definitely use blue loctite on the fasteners. Also, be advised that there are a couple of nuts, not bolts, on the rear suspension that GM advises to never reuse. LCA and one other if I recall correctly. It’s best to look at the GM service manual for instructions just to be certain of what you’re getting into with the fasteners. Good luck with install.
|
04-12-2020, 10:11 PM | #5 | |
Drives: 2014 1le 1SS CRMT Join Date: Apr 2014
Location: Boston mass
Posts: 1,178
|
Quote:
|
|
|
|
|
|