10-27-2020, 09:55 AM | #1 |
Drives: 2012 Camaro SS 45th Anniversary Join Date: Aug 2020
Location: Houston
Posts: 60
|
Clunking noise after lowering springs
So I just bought some BMR 1.25 lowering springs and I am pretty sure I installed them on right. I even had my mechanic help me out. I have yet to get an alignment but when I took it for a drive it would make a clunking noise especially on the driver front side when going over bumps or any imperfection on the road. Any suggestions on what it could be?
|
10-27-2020, 02:09 PM | #2 |
Drives: T Join Date: Mar 2015
Location: CA
Posts: 803
|
sway bar mounts front and back, if they have seated a long time its going to fidget a bit especially if its dry from not being greased. I'd look there first. I swapped out all new mount bushings its silent now.
|
10-27-2020, 03:21 PM | #3 |
Drives: Race Car Join Date: Sep 2009
Location: Seffner, FL
Posts: 6,226
|
Clunking is usually Swaybar related - Check to see if you Brackets are tight
|
10-28-2020, 05:04 PM | #4 |
|
Take it back and have them time your bushings. This happened to me and fixed it immediately.
Sent from my iPhone using Tapatalk
__________________
Cold Air Inductions CAI Stainless Power LT's with HFC's Flowmaster American Thunder Cat Back APEX Scoop and WW Relocation Kit VMAX Ported Throttle Body Custom Dyno Tune Pfadt 1.25" Lowering Springs ZL1 Rims on 275 front 315 Rear custome underlay vinyl wrap Anvil Spoiler heritage grill APR Front Splitter Custom Emblempros emblems ZL1 Side Skirts 416.5 whp 410 torque (CURRENTLY) Up Next: BTR Stage 3 Cam and supporting mods (in garage now)
|
|
|
Thread Tools | |
|
|