need help wiring JL cleansweep - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

426hpss · 03-29-2010, 09:43 PM

i have a 1ss without the BA system, i need inputs from thefront and rear speakers, also the remote wire. i have read all the post and there is no direction to show me how. can anyone help, pics would really help.
thanks jay

Iomcamaro · 03-30-2010, 10:41 AM

are you installing subs?

426hpss · 03-30-2010, 11:56 AM

yes

Droid6 · 03-30-2010, 06:27 PM

There's a post here by a guy from JLAudio saying the Camaro doesn't need the clean sweep because the stock deck doesn't add any equalization to the signal.

Topdown · 04-01-2010, 04:52 PM

Quote:

Originally Posted by Droid6

There's a post here by a guy from JLAudio saying the Camaro doesn't need the clean sweep because the stock deck doesn't add any equalization to the signal.

Good info to have right there...

Hess RS · 04-06-2010, 02:06 AM

Ive only worked on cars with the BA system, and Im assuming that the non-BA system doesnt have an amp, is that correct?

Droid6 · 04-07-2010, 09:30 AM

Quote:

Originally Posted by ltlaudio

Ive only worked on cars with the BA system, and Im assuming that the non-BA system doesnt have an amp, is that correct?

I'm pretty sure there is no amp in the non-ba system. I was going to look to see where the low voltage wires that would go to the ba amp are so I could tap into them for a clean RCA install.

strauchpete · 04-07-2010, 09:38 AM

I did a clean sweep on my car with out BA.
If you are just doing it as for sub woofers you really dont need a clean sweep you would need more like an audiocontrol line driver.
If you are replacing all of the speakers in the car and adding 4 channel amp you need a cleansweep and a summoning device for the clean sweep since the signals are crossed over you need the summoning device to put it back not crossed over then from there you run it into the clean sweep.

strauchpete · 04-07-2010, 09:42 AM

Quote:

Originally Posted by Droid6

There's a post here by a guy from JLAudio saying the Camaro doesn't need the clean sweep because the stock deck doesn't add any equalization to the signal.

Strange if that is someone from JL because I called JL ,we are a dealer of them, and told them what I wanted to do and they said I would need a cleansweep and the summoning device for it.

third1 · 04-07-2010, 10:56 AM

I think you could get by without it.I tested the line ins on the amp and they all had .6 volts going into the amp.

strauchpete · 04-07-2010, 11:15 AM

.6 v at what volume, I never bothered to test my wiring for it. Only thing that if it is .6 v max I would at least put a line driver on it to boost the voltage to the amp.

2010SLVRBULIT · 04-07-2010, 11:23 AM

Audiocontrol processors are the shitz..

third1 · 04-08-2010, 08:45 AM

That was .6 at a very low volume. I didn't take a chance and added a Rockford Fosgate 360.1 that I had. I just have to fine tune it.

Go Fast Kid · 04-11-2010, 10:34 AM

I spoke with the audio engineers at JL Audio, they analyized the head unit on thier test bench. They believe the dynamic audio range of the head unit is so good no clean sweep is needed.

They did recommend replacing all the speakers and amp which are the week link in the audio system

03-29-2010, 09:43 PM	#1
426hpss Drives: black 2010 1ss rs Join Date: Dec 2009 Location: toronto Posts: 12	need help wiring JL cleansweep i have a 1ss without the BA system, i need inputs from thefront and rear speakers, also the remote wire. i have read all the post and there is no direction to show me how. can anyone help, pics would really help. thanks jay

04-07-2010, 10:56 AM	#10
third1 speed freak Drives: 2015i Cadillac Escalade,10 IOM 2ss Join Date: Jun 2009 Location: Neenah Wi Posts: 1,143 View My Garage	I think you could get by without it.I tested the line ins on the amp and they all had .6 volts going into the amp. __________________ Current:2015i Cadilac Escalade,2016 Lexus RC350,2011 CVO StreetGlide cammed,tuned & loud. 2010 IMO/IO,custom stripes,GFX,sunrf,solo exhaust,JBA shorties,rotofab,Jannetty tune,Pfadt,JLw6 Audison&Hertz,7/4/09 2GIFKIEJ6A9123779Del 7/10/09 Former Camaros 72 LT1 Z28, 86 z28 [SIGPIC]

04-08-2010, 08:45 AM	#13
third1 speed freak Drives: 2015i Cadillac Escalade,10 IOM 2ss Join Date: Jun 2009 Location: Neenah Wi Posts: 1,143 View My Garage	That was .6 at a very low volume. I didn't take a chance and added a Rockford Fosgate 360.1 that I had. I just have to fine tune it. __________________ Current:2015i Cadilac Escalade,2016 Lexus RC350,2011 CVO StreetGlide cammed,tuned & loud. 2010 IMO/IO,custom stripes,GFX,sunrf,solo exhaust,JBA shorties,rotofab,Jannetty tune,Pfadt,JLw6 Audison&Hertz,7/4/09 2GIFKIEJ6A9123779Del 7/10/09 Former Camaros 72 LT1 Z28, 86 z28 [SIGPIC]

04-11-2010, 10:34 AM	#14
Go Fast Kid Drives: Camaro 2010 SS LS7 427ci Join Date: Nov 2009 Location: Miami Posts: 61	Clean sweep install I spoke with the audio engineers at JL Audio, they analyized the head unit on thier test bench. They believe the dynamic audio range of the head unit is so good no clean sweep is needed. They did recommend replacing all the speakers and amp which are the week link in the audio system

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BCM wiring	HaZe_X	5th Gen Camaro SS LS LT General Discussions	5	09-26-2019 11:28 AM
Urgent help needed- rear speaker/sub wiring	Arachnyd	Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum	1	01-13-2010 08:35 PM
Camaro Factory Wiring Diagrams	speedster	Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum	3	12-15-2009 04:38 PM
Anyone have picts/info on the factory infotainment system wiring harness & plugs?	Matt'sSS	Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum	3	10-01-2009 12:48 AM

03-30-2010, 10:41 AM	#2
Iomcamaro The enjoyment never ends Drives: 2010 1LT/RS IOM #25223 Join Date: May 2009 Location: NKY Posts: 1,086	are you installing subs?

03-30-2010, 11:56 AM	#3
426hpss Drives: black 2010 1ss rs Join Date: Dec 2009 Location: toronto Posts: 12	yes

03-30-2010, 06:27 PM	#4
Droid6 Drives: 2010 Camaro LS Join Date: Mar 2010 Location: Chesapeake, VA Posts: 291	There's a post here by a guy from JLAudio saying the Camaro doesn't need the clean sweep because the stock deck doesn't add any equalization to the signal.

04-06-2010, 02:06 AM	#6
Hess RS Account Suspended Drives: 91 Camaro RS Join Date: Sep 2009 Location: Anaheim Hills, CA Posts: 324	Ive only worked on cars with the BA system, and Im assuming that the non-BA system doesnt have an amp, is that correct?

04-07-2010, 09:38 AM	#8
strauchpete Account Suspended Drives: 2010 Camaro 1LT Join Date: Dec 2009 Location: Sedalia, Missouri Posts: 338 View My Garage	I did a clean sweep on my car with out BA. If you are just doing it as for sub woofers you really dont need a clean sweep you would need more like an audiocontrol line driver. If you are replacing all of the speakers in the car and adding 4 channel amp you need a cleansweep and a summoning device for the clean sweep since the signals are crossed over you need the summoning device to put it back not crossed over then from there you run it into the clean sweep.

04-07-2010, 11:15 AM	#11
strauchpete Account Suspended Drives: 2010 Camaro 1LT Join Date: Dec 2009 Location: Sedalia, Missouri Posts: 338 View My Garage	.6 v at what volume, I never bothered to test my wiring for it. Only thing that if it is .6 v max I would at least put a line driver on it to boost the voltage to the amp.

04-07-2010, 11:23 AM	#12
2010SLVRBULIT Drives: G5(LLT) & C6(LS3) Join Date: Apr 2009 Location: MARS Posts: 7,527 View My Garage	Audiocontrol processors are the shitz..