08-10-2011, 03:49 PM | #1 |
#42,288
|
Starter Keeps on Turning Over Even When Running
I turn on the car, the engine starts and the starter stays engaged. I have had it in the dealer for this problem twice now and of course it never happens when they have it...half a tank of gas later and 100 miles by the dealer.
The first time I took it in the dealership replaced the starter and flywheel, but its happened again, and again, and again. Anyone else with this problem? Though patient I think the dealer thinks I'm nuts.
__________________
Darren |
08-10-2011, 08:54 PM | #2 |
Drives: 2011 Camaro 2SS/RS CGM/BLI A6 Join Date: Jul 2011
Location: Palmetto, FL
Posts: 980
|
Sounds like a defective ignition switch.
__________________
Dan Wheldon (1978-2011)
MODS: RX Performance catch can, Jegs CAI, ZL1 grille, chrome license plate frame, GM locking gas cap, Defender Worx chrome DRL bezels, GM molded splash guards, Oracle LED side markers, DRLs, tag lights and reverse lamps, Technostalgia Rapid Fire tail lamps, Vitesse shift paddle extenders, MBRP cat back. FUTURE: long tube headers, front splitter, slotted/drilled rotors, leather console and e-brake handle boot, remote fuel door and rear seat release, sway bars and bushings. WISH LIST: Edelbrock E-Force SC, LS3 conversion |
08-10-2011, 09:31 PM | #3 |
Drives: 550+RWHP 2010 camaro Join Date: Sep 2007
Location: wisconsin
Posts: 1,588
|
the ignition switch is not wired to the starter like old vehicles
ignition switch does not start these vehicles, the ignition switch is nothing more than a request signal sent to the bcm to start the vehicle, if the bcm (and tcm for l99's) see's all data that it needs to start"ok" it then sends a signal to the ecm to command the starter to crank you can have your camaro running and try to crank the engine again and it wont allow the starter to engage the flywheel when the engine is running sounds like a bad starter relay or ecm / bcm, or wiring issue to the starter relay
__________________
415ci stroker, TVS 2300 Magnacharger, cnc heads, cam, yank ss3200 converter, Kooks long tubes, Bwoody true cold air kit, ZL1 Pump, magnaflow 3" cat-back, lowering springs,BMR control arms and tie rod bars, 3.73 gears, diff mounts, RX can, ADM fuel controller
|
08-12-2011, 12:52 PM | #4 |
Drives: GM Vehicles Join Date: Jun 2010
Location: Michigan
Posts: 9,328
|
You may want to see if your dealer can keep it over night to get it on a cold start to see if that might help in diagnosing it on their end. If that fails let me know and I'll do what I can to assist you.
Jeff Morris, Chevrolet Customer Service |
09-04-2011, 09:11 AM | #5 |
#42,288
|
Thanks, they kept it for two weeks but of course it didn't fail. Now it cranks without starting. It is going back in yet again. Pretty frustrating but it is happening more often.
__________________
Darren |
09-05-2011, 02:33 PM | #6 |
Just Because!
Drives: 2010 SIM 2SSRS Join Date: Jun 2010
Location: San Jose, Ca
Posts: 6,909
|
Crank Position Sensor is faulty... Ive got 1 ice cold beverage riding on it! Let us know what you find out.
__________________
|
09-05-2011, 03:10 PM | #7 |
buzzy56
|
try another
I would try another dealer. Different eyes might help resolve this issue.That many miles and too have the car that long and not correct the problem speaks a lot about their expertise.I like the previous response above.Hope you get it resolved. Nothing worse than a car that is not dependable.Nor a dealer that just keeps changing parts hoping to solve a problem.
__________________
OLD SCHOOL / NEW SCHOOL COOL
|
09-05-2011, 04:24 PM | #8 |
#42,288
|
Thanks for the great advice. I am calling tomorrow!
__________________
Darren |
09-06-2011, 12:22 PM | #9 |
Drives: Camaro 2SS/RS Join Date: Aug 2009
Location: MD
Posts: 145
|
I replaced a starter on a much older car and pinched a wire causing it to short and the starter to run continuously till it burnt up. Does anyone think it could be a wire shorting out, or are there too many sensors and computers involved now a days for it to be that simple.
__________________
|
09-08-2011, 06:54 AM | #10 |
Drives: 2ss red m6 Join Date: Dec 2009
Location: grosse tete
Posts: 215
|
I don't think there is anything wrong with your car,,,,,,,,, if you start to crank your car and let up it will continue to crank on it's own,,,the PCM is the cause,,,,it is a normal thing,,,,,,,,, now if the car is still cranking after the engine starts running that's a different story. There is a bulletin on this and I give it to my customers all the time. It feels like the car is cranking on it's own or the starter is sticking,,,,,,, good luck
|
09-08-2011, 07:16 AM | #11 |
Drives: 2011 Camaro 2LT Join Date: Aug 2011
Location: Denver, CO
Posts: 11
|
I had this problem on my Chevy Silverado some years back. Its a sticking solenoid on the starter. Tell them to replace the solenoid or the entire starter. It will keep happening and finally will stay that way
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need Help with starter disable hidden switch | wjmeyer | Camaro DIY & HOW-TO instructions & discussions | 7 | 04-06-2013 06:40 PM |
So what size 22" tires is everyone running ? | 1DERZ SS | Wheels and Tires Talk Sponsored by The Tire Rack | 23 | 02-28-2012 04:45 PM |
RS Running Lights | pennor | 5th Gen Camaro SS LS LT General Discussions | 32 | 03-24-2011 09:20 PM |
How do I get my Fog Lights to act as my Day time Running Lights??? | Camaro Freak | 5th Gen Camaro SS LS LT General Discussions | 8 | 10-12-2010 04:16 PM |
Longtube owners, I am running too rich! | Blade | Camaro V6 LLT Engine, Exhaust, and Bolt-Ons | 29 | 07-02-2010 09:06 AM |