Need clutch recommendations

[SS Performance]

I'm building a dedicated track car, https://www.camaro5.com/forums/showthread.php?t=555440.

The car currently has a A6 but I plan to switch to a M6. I am most likely going to use the TR6060 out of a ZL1.

My motor is a LS2 bored and stroked using a LSX454 rotating assembly, LS7 heads, Holley Hi-Ram intake and Brian Tooley cam. I expect to be making 700+ hp and will be keeping the RPM's under 7000.

I am not sure what clutch would be best. I can go with a stock clutch for the ZL1 or aftermarket like the McLeod RST, or something else.

I was wondering what others are using and what their experiences are.

Thanks
Craig

[ronchev]

Originally Posted by SS Performance

I'm building a dedicated track car, https://www.camaro5.com/forums/showthread.php?t=555440.

The car currently has a A6 but I plan to switch to a M6. I am most likely going to use the TR6060 out of a ZL1.

My motor is a LS2 bored and stroked using a LSX454 rotating assembly, LS7 heads, Holley Hi-Ram intake and Brian Tooley cam. I expect to be making 700+ hp and will be keeping the RPM's under 7000.

I am not sure what clutch would be best. I can go with a stock clutch for the ZL1 or aftermarket like the McLeod RST, or something else.

I was wondering what others are using and what their experiences are.

Thanks
Craig

I went with Diamond Stage 2 with billet flywheel for the 15 pound weight savings over stock on my LS7 that is just over 700hp at the crankshaft with a Mamo top end package, clutch is holding fine but does feel a little soft or mushy in the upper RPM range for whatever reason but plans are to go with something better at some point here. Clutch was done for the lighter rotating mass before engine mods were done.

Interested in what others have used as well

[Juiced1]

We've done a few builds using the Mantic twin disc clutch. Customers have been very happy so far.