BA mylink Radio - High or low level inputs?

[Leo72793]

Originally Posted by ghost0217

You know, I didn't even think about that but you're right. It will still send the signal for the backup beeping, just to the fronts. Then I can run the front's active and just skip the rears. In all the years I've been playing with this stuff, I've yet to go active and yet to omit rear fill. If I do this, I may end up selling all my speakers and getting a nicer set of comps for the front. I was looking at a set of Focal P165 v15's earlier today. I've used components but never anything over $200'ish dollars and never anything by Focal/Hertz/MB/Dyn/etc. I also found a Focal Polyglass 27v sub locally and was wondering how nice it is. We'll see, keep everyone posted.

Thanks,
Ghost

I went actuve ( pita get custom a pillar covers made ) My bud has hertz 2 ways in his truck and they are nice. I wont spend money on focal speakers anymore. Their warranty sucks. Wouldnt warrant a known heat warp issue.

Look this video. this is front 2 way active no sub ( doors sealed and speaker rings installed to seal them to the door panel.

https://youtu.be/WHiqzuMP8j4

[jeffa]

Originally Posted by Leo72793

the mylink may be different. All i know is i checked everything and the voltage was not 4-6 at all.

The 2013 and up MyLinks with the BA system are low level outputs.

Since I do not have the 2010-2011 non MyLink BA system, I cannot confirm if this radio had low level outputs to the BA amplifier.

[Leo72793]

Originally Posted by jeffa

The 2013 and up MyLinks with the BA system are low level outputs.

Since I do not have the 2010-2011 non MyLink BA system, I cannot confirm if this radio had low level outputs to the BA amplifier.

When i measured my 10, it was well over the accepted input voltage on most amps. ( taking max 6v )

[ghost0217]

Originally Posted by Leo72793

When i measured my 10, it was well over the accepted input voltage on most amps. ( taking max 6v )

This may be the difference that I have been seeing throughout different threads/posts. Maybe the guys that say they can't crack the gains have the non MyLink BA headunits from the 10-13 cars and maybe the MyLink BA headunits from the 14-15 cars are lower voltage.

I plan to find out soon enough. Once I get everything together, I can post back with my findings on voltage from 15 MyLink w Nav BA headunit.

Thanks again guys,
Ghost