JANNETTY RACING DIPSTICK & TUBE KITS 6L80E & 6L90E - Page 4 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

oldirtybrew · 06-30-2017, 02:54 PM

Hello, is the Jannetty dipstick and tube compatible with the B&M Racing deep transmission pan (http://www.bmracing.com/products/703...-ss-automatic/) and does it accurately measure its fluid level since it has a 1.8 quart greater capacity than the stock pan???

JANNETTYRACING · 06-30-2017, 04:15 PM

Quote:

Originally Posted by oldirtybrew

Hello, is the Jannetty dipstick and tube compatible with the B&M Racing deep transmission pan (http://www.bmracing.com/products/703...-ss-automatic/) and does it accurately measure its fluid level since it has a 1.8 quart greater capacity than the stock pan???

Yes sir, does not matter how deep the pan is the level is in relation to the case.

Our dipstick tube kit will make the level correct.

Thank you for your interest in JRE performance products.

oldirtybrew · 06-30-2017, 09:22 PM

Thank you sir! I'm ordering one of your Jannetty dipsticks right now!!!

JANNETTYRACING · 07-01-2017, 08:40 AM

Quote:

Originally Posted by oldirtybrew

Thank you sir! I'm ordering one of your Jannetty dipsticks right now!!!

Thank you for your business!

oldirtybrew · 07-01-2017, 12:22 PM

You're welcome! Thank you for sharing so much of your knowledge with everyone on this forum! Over the past 3 years, I have read and learned a lot from your many contributions. -Russell

JANNETTYRACING · 07-31-2017, 10:29 AM

Quote:

Originally Posted by oldirtybrew

You're welcome! Thank you for sharing so much of your knowledge with everyone on this forum! Over the past 3 years, I have read and learned a lot from your many contributions. -Russell

JANNETTYRACING · 10-07-2017, 10:02 AM

If you have not seen these check them out they are a great addition to any build.

We found they also fit the G8 and Impala and expect they will fit many more models.

JANNETTYRACING · 12-02-2017, 07:59 AM

Great Christmas gift.

frack · 12-13-2017, 09:14 AM

Ordered mine a few days ago. Got it last night. I put the car up at 8:30 am this morning and was by done 9:55 am. Would have been done sooner but, the wires near the starter block everything. Messed with those for about 30 minutes just trying to get them into good position. Seems to seal to tranny pretty well. I got the car to operating temperature and ran through gears a few times. Seem to be no leaks. Will see when car is under a full load. Thanks Ted

JANNETTYRACING · 12-13-2017, 09:29 AM

Quote:

Originally Posted by frack

Ordered mine a few days ago. Got it last night. I put the car up at 8:30 am this morning and was by done 9:55 am. Would have been done sooner but, the wires near the starter block everything. Messed with those for about 30 minutes just trying to get them into good position. Seems to seal to tranny pretty well. I got the car to operating temperature and ran through gears a few times. Seem to be no leaks. Will see when car is under a full load. Thanks Ted

AWESOME thank you for the feedback.

Merry Christmas.

Ted.

JANNETTYRACING · 01-27-2018, 10:26 AM

Great addition to any build hard to keep up with the sales on these, thanks for the orders

JANNETTYRACING · 01-30-2018, 09:38 AM

Cars we know if fits besides the V8 Gen 5 Camaro with 6L80E and 6L90E

CTSV with 6L80E

CTSV with 6L90E

Pontiac G8 with 6L80E

Holden Commodore w 6L80E and 6L90E

Holden Special Vehicles S series with 6L80E

Holden Special Vehicles GTS Series with LSA and 6L90E

Chevrolet SS V8 with 6L80E

Caprice PPV V8 with 6L80E

We will add to this list as more info becomes available.

If anyone wants to try and fit one to they car contact me directly tedj@jannettyracing.com for a no risk trial.

Ted.

LCPLPunk · 01-31-2018, 05:37 PM

Ted! Where do I order? I clicked on the link in the first post and it gave me a 404 Not Found error...

JANNETTYRACING · 02-01-2018, 07:58 AM

Quote:

Originally Posted by LCPLPunk

Ted! Where do I order? I clicked on the link in the first post and it gave me a 404 Not Found error...

Sorry about that, we launched a new Web site on Monday.

www.jreperformanceparts.com check it out.

Thank you for your business.

Ted.

10-07-2017, 10:02 AM	#49
JANNETTYRACING Drives: BLUE CAMARO ZL1 1LE M6 Join Date: Jun 2009 Location: ON THE DYNO WATERBURY CT. Posts: 15,225	If you have not seen these check them out they are a great addition to any build. We found they also fit the G8 and Impala and expect they will fit many more models. __________________ www.jannettyracing.com Celebrating 37 years Performance parts, Installation, Fabrication, Dyno tuning, Remote custom tuning, and alignments. 203-753-7223 Waterbury CT. 06705 email tedj@jannettyracing.com

12-02-2017, 07:59 AM	#50
JANNETTYRACING Drives: BLUE CAMARO ZL1 1LE M6 Join Date: Jun 2009 Location: ON THE DYNO WATERBURY CT. Posts: 15,225	Great Christmas gift. __________________ www.jannettyracing.com Celebrating 37 years Performance parts, Installation, Fabrication, Dyno tuning, Remote custom tuning, and alignments. 203-753-7223 Waterbury CT. 06705 email tedj@jannettyracing.com

12-13-2017, 09:14 AM	#51
frack Drives: 2010 Inferno Orange SS Join Date: Sep 2014 Location: United States Posts: 120 View My Garage	Ordered mine a few days ago. Got it last night. I put the car up at 8:30 am this morning and was by done 9:55 am. Would have been done sooner but, the wires near the starter block everything. Messed with those for about 30 minutes just trying to get them into good position. Seems to seal to tranny pretty well. I got the car to operating temperature and ran through gears a few times. Seem to be no leaks. Will see when car is under a full load. Thanks Ted
$frack is offline$

01-27-2018, 10:26 AM	#53
JANNETTYRACING Drives: BLUE CAMARO ZL1 1LE M6 Join Date: Jun 2009 Location: ON THE DYNO WATERBURY CT. Posts: 15,225	Great addition to any build hard to keep up with the sales on these, thanks for the orders __________________ www.jannettyracing.com Celebrating 37 years Performance parts, Installation, Fabrication, Dyno tuning, Remote custom tuning, and alignments. 203-753-7223 Waterbury CT. 06705 email tedj@jannettyracing.com

01-30-2018, 09:38 AM	#54
JANNETTYRACING Drives: BLUE CAMARO ZL1 1LE M6 Join Date: Jun 2009 Location: ON THE DYNO WATERBURY CT. Posts: 15,225	Cars we know if fits besides the V8 Gen 5 Camaro with 6L80E and 6L90E CTSV with 6L80E CTSV with 6L90E Pontiac G8 with 6L80E Holden Commodore w 6L80E and 6L90E Holden Special Vehicles S series with 6L80E Holden Special Vehicles GTS Series with LSA and 6L90E Chevrolet SS V8 with 6L80E Caprice PPV V8 with 6L80E We will add to this list as more info becomes available. If anyone wants to try and fit one to they car contact me directly tedj@jannettyracing.com for a no risk trial. Ted. __________________ www.jannettyracing.com Celebrating 37 years Performance parts, Installation, Fabrication, Dyno tuning, Remote custom tuning, and alignments. 203-753-7223 Waterbury CT. 06705 email tedj@jannettyracing.com

06-30-2017, 02:54 PM	#43
oldirtybrew Drives: Silver 2012 Camaro 2SS Join Date: Aug 2014 Location: Fayetteville, NC Posts: 25 View My Garage	Hello, is the Jannetty dipstick and tube compatible with the B&M Racing deep transmission pan (http://www.bmracing.com/products/703...-ss-automatic/) and does it accurately measure its fluid level since it has a 1.8 quart greater capacity than the stock pan???

06-30-2017, 09:22 PM	#45
oldirtybrew Drives: Silver 2012 Camaro 2SS Join Date: Aug 2014 Location: Fayetteville, NC Posts: 25 View My Garage	Thank you sir! I'm ordering one of your Jannetty dipsticks right now!!!

07-01-2017, 12:22 PM	#47
oldirtybrew Drives: Silver 2012 Camaro 2SS Join Date: Aug 2014 Location: Fayetteville, NC Posts: 25 View My Garage	You're welcome! Thank you for sharing so much of your knowledge with everyone on this forum! Over the past 3 years, I have read and learned a lot from your many contributions. -Russell

01-31-2018, 05:37 PM	#55
LCPLPunk USA-1 Drives: 2010 Camaro SS L99 Join Date: Jul 2016 Location: Near DC Posts: 1,893 View My Garage	Ted! Where do I order? I clicked on the link in the first post and it gave me a 404 Not Found error... __________________ "A Camaro in the garage is safe, but that's not what Camaros are built for..." R2C CAI / Apex Scoop / VMAX Ported TB / Speed Engineering LTHs / X-pipe / GPI port/rod-mod intake manifold / Circle D 3200 278mm Converter / 3.91 gears / DynoSteve tuned / 1LE Shocks/Struts/Toe Links / ZL1 Rear Sway Bar / Z/28 Trailing arms / Prothane Radius Arm & Subframe Bushings / BMR UCA Bracket, Steering rack bushing / B&M Tranny Cooler / RX Catch Can / Jannetty Tranny Dipstick / 2012+ Heater Hose / 2013+ Rearview Mirror / Fuel rail flip / Drake shifter / Oil Cooler Delete