need a little advice - Page 3 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

Avenging Orange · 03-17-2016, 04:00 PM

Quote:

Originally Posted by Mr. Stacy

IIRC, LFX OEM headers are integrated with the engine. So no option for aftermarket, bolt-on headers.

Ahhh, I see. Thank you.

Mr. Stacy · 03-17-2016, 06:16 PM

Quote:

Originally Posted by arkentect

DO NOT waste your money on an axle back exhaust. It would make sense if they all weren't $350+ but in reality you can go to an exhaust shop and have a custom bent exhaust built for much cheaper.
My exhaust isnt for everyone bc it does have a weee bit of drone on the highway but hell to me its worth the deeper tone it has during idle and revving.

Custom Catback exhaust, removed the stock resonators and replaced them with a Magnaflow Resonated XPipe. From there its straight piped back to the 4" tips. Sounds even better than this in person. $250 out the door.

That sounds great for that price! I should have done that.

Your pipes looks very tight on the diffuser in that shot. Does it have clearance? Does it (diffuser) get hot?

1Coopgt · 03-17-2016, 06:46 PM

Quote:

Originally Posted by RubyCamaro

Borla makes the GMPP exhaust & their V6 exhaust sounds great. It is still quiet at idle & cruise but gives a good growl on WOT & start-up. Check the V6 section where you will find a lot of videos of the different set-ups. Mine is a 2010 so I have the LLT engine but the sound is similar. Here is mine.

Quote:

Originally Posted by SnowyCamaro

+1 I had the borla and it sounded great (for a v6). Very little drone so not annoying on the highway.

What these 2 said. I have the GMPP, love it . And it sounds great .

arkentect · 03-17-2016, 08:54 PM

Quote:

Originally Posted by Mr. Stacy

That sounds great for that price! I should have done that.

Your pipes looks very tight on the diffuser in that shot. Does it have clearance? Does it (diffuser) get hot?

This was the day after I had it done, the pipes were a little tight probably a ¼" gap but have since have been adjusted to center of the diffuser holes

Tristahn · 03-18-2016, 12:54 AM

My friend did the deletes like arkentect and it sounds about the same as his video. Seriously I think he paid $60 bucks and it's tough sounding. If you dislike the sound then go back and play with a different muffler and exhaust setup and spend the money.

03-18-2016, 12:54 AM	#33
Tristahn 2011 2SS LS3 Auto Drives: 2011 Camaro SS Join Date: Feb 2015 Location: Phoenix, AZ Posts: 63	My friend did the deletes like arkentect and it sounds about the same as his video. Seriously I think he paid $60 bucks and it's tough sounding. If you dislike the sound then go back and play with a different muffler and exhaust setup and spend the money.