05-11-2014, 12:23 PM | #1 |
Drives: 2010 LT Join Date: Oct 2013
Location: USA
Posts: 174
|
Cost to repair dents/paint chips?
So Im curious what the estimated cost would be to remove the dents in the pictures below and the paint chips, also correct the incorrect touch up paint... Advice would be appreciated. Also would there be a way I could fix this up correctly?
|
05-11-2014, 01:35 PM | #2 |
Mid-Florida Camaro Club
|
Most PDR people will charge 75 to 100 per dent. Paint repair is outside my knowledge.
|
05-11-2014, 01:49 PM | #3 |
Drives: 19 Z06 Join Date: Nov 2011
Location: Oakville Ont.
Posts: 1,427
|
In your 3rd photo I think you could do it yourself with Dr. Colorchip and get good results
In your first pic a PDR guy could probably get that out but it looks like you have a break (crack) in the paint. There is a new clear process where they can bond to the clear without repainting the whole fender. I forget whats its called, but the clear they spray on bonds to the existing clear and its polished so they don't have to do the whole panel. In your 3rd pic, I think you need a body shop as it looks repainted, Just my two cents
__________________
Gone but not forgotten:
1974 Corvette Stingray 454 1986 Z28 2009 Mustang GT convertible 2012 45th 2SS Vert 2013 ZL1 M6 2014 Zl1 M6 2014 GT500 2016 Challenger Hellcat M6 www.youtube.com/c/garageking |
05-11-2014, 02:08 PM | #4 |
Drives: 2010 LT Join Date: Oct 2013
Location: USA
Posts: 174
|
|
05-12-2014, 07:28 PM | #5 |
Drives: 2010 LT Join Date: Oct 2013
Location: USA
Posts: 174
|
I just hot quoted 1000 for the fender and bumper...
|
05-13-2014, 09:26 AM | #6 |
Drives: 2012 LT RS Join Date: Jun 2012
Location: Texas
Posts: 83
|
I know that the guys that i take my car to have any major paint work done quoated me about $350 for fixing a dent in my pasanger door repainting. I dont think it should cost you too much, BUT make sure they use a decent quality paint... I went rouge once and trusted some 'other' guys to paint my rear bumper; their paint job didn't finish out smooth and reflective like stock paint.
|
05-13-2014, 09:37 AM | #7 |
Drives: 2010 Camaro 2SS/RS Join Date: Aug 2012
Location: Cordova, TN
Posts: 774
|
If the dent is something that can't be pulled out.. the whole body piece would have to be sanded, fixed and repainted which gets expensive (mainly for cost of paint). I was quoted $700 on one dent for supplies and labor for 1 dent on my door.
__________________
2010 Camaro 2SS M6
2" Stainless Power Longtube Headers 3" Full exhaust w/ Off-Road H-Pipe Bo White Ported Throttle Body Hurst Short Throw Shifter Best Time: 12.43 @ 114, 1.99 60' on stock wheels and stock tires Build Thread |
05-13-2014, 09:08 PM | #8 |
Drives: 2010 LT Join Date: Oct 2013
Location: USA
Posts: 174
|
It's crazy little minor things like this cost so much. Is it possible insurance would cover this?
|
05-14-2014, 09:07 PM | #9 |
M0yn
Drives: 2011 Camaro Inferno Orange Metallic Join Date: Aug 2011
Location: Rochester, NY
Posts: 189
|
Insurance will cover it, I had something like this happen. $1000 to fix, but it was def worse off then what you have. So I claimed it to my insurance company. Honestly it doesn't look that bad, I would try fixing that myself. For the wrong touch up paint, what did you use? Maybe get the Langka blotter remover and try that? I just used touch up paint and the Langka system and it worked great!
|
05-15-2014, 01:01 AM | #10 | |
Drives: 2010 LT Join Date: Oct 2013
Location: USA
Posts: 174
|
Quote:
|
|
05-27-2014, 10:20 AM | #11 |
Drives: 2010 Camaro 2SS/RS Join Date: Aug 2012
Location: Cordova, TN
Posts: 774
|
Depends on your policy. I have full coverage so any and all cosmetic damage is covered as long as I pay my part of the deductible. For other people who have lesser insurance, they'd have to check their policy to see what kind of cosmetics would be covered. That $700 I was quoted from the body shop that I mentioned in a previous post was not with insurance... that was direct from the body shop if I were to pay the whole expense out of pocket.
__________________
2010 Camaro 2SS M6
2" Stainless Power Longtube Headers 3" Full exhaust w/ Off-Road H-Pipe Bo White Ported Throttle Body Hurst Short Throw Shifter Best Time: 12.43 @ 114, 1.99 60' on stock wheels and stock tires Build Thread |
05-27-2014, 10:28 AM | #12 |
Writer
Drives: 2010 SS / 1967 Camaro Join Date: May 2009
Location: Chicago, IL
Posts: 7,216
|
I pay $50-100 per ding. I go to a buddy who does cash, and I usually wait until I have 3 dings and then he shoots me a number.
I'd like to learn more about Dr. Color Chip.
__________________
PROJECT HEAVY CHEVY
Camaro Now: Mods for the Masses Part I | Part II 13.15@106 1.95 | 100% Stock 12.37@112 1.85 | + Kooks Headers/Cats + 20" 555R + CAI + BW TB + UDP + Tune 12.06@113 1.70 | + CD 3200 + 18" NT05R + RCR Intake + NE OTR + GPI Tune 11.84@115 1.59 | + 3.91s + Race Star 17x7 Fronts 10.90@125 1.47 | + GPI VVT Cam + BW Ported Heads + CD 3800 |
05-27-2014, 10:45 AM | #13 |
Drives: 2014 2SS/RS Factory Short Throw M6 Join Date: Oct 2013
Location: Daphne, AL
Posts: 47
|
My car is in the shop as we speak for dent/paint repair on a marble size dent/paint chip in the "shark gills" fake brake vents on the driver side with 2 smaller "shrapnel from initial impact" dents and paint scuffs. Costing me $640 bucks.
|
|
|
|
|