radio code U0184-00 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

buicfrank · 12-27-2019, 09:56 PM

Has anyone encountered the above code? Working on a 2014 1LS. First posting.
Thanks Frank.

GHOSTRIDER-R · 03-16-2020, 08:37 AM

Quote:

Originally Posted by buicfrank

Has anyone encountered the above code? Working on a 2014 1LS. First posting.
Thanks Frank.

anyone find anything my car just started this to :-( 46k 2013

Mouse330 · 03-27-2020, 04:42 PM

u0184 is a loss of communication with the radio.
does the radio work?
heating a/c working properly?
most of the time i find it needs a radio
if it does it would have to be programmed after install.
some testing here

1. Remove the Radio.

2. Verify power on the Red/White wire at pin 44 in the X1 connector. It is fuse F3RA in the Fuse Block-Rear Body that powers the circuit.

3. Verify a good ground on the Black wire at pin 38 in the X1 connector.

4. At key on, engine off, verify the fuel gauge is working. Locate and ground the Dark Green wire at pin 28 in the X1 connector.

5. Verify 3-10 seconds after grounding that the fuel gauge drops to empty.

6. If OK replace the Radio assembly. Programming is required after installation.

12-27-2019, 09:56 PM	#1
buicfrank Drives: 2014 chevrolet camaro Join Date: Dec 2019 Location: new castle, pa Posts: 1	radio code U0184-00 Has anyone encountered the above code? Working on a 2014 1LS. First posting. Thanks Frank.

03-27-2020, 04:42 PM	#3
Mouse330 Drives: 2011 2SS, 2006 GMC Sierra Join Date: Jul 2019 Location: MA Posts: 240	u0184 is a loss of communication with the radio. does the radio work? heating a/c working properly? most of the time i find it needs a radio if it does it would have to be programmed after install. some testing here 1. Remove the Radio. 2. Verify power on the Red/White wire at pin 44 in the X1 connector. It is fuse F3RA in the Fuse Block-Rear Body that powers the circuit. 3. Verify a good ground on the Black wire at pin 38 in the X1 connector. 4. At key on, engine off, verify the fuel gauge is working. Locate and ground the Dark Green wire at pin 28 in the X1 connector. 5. Verify 3-10 seconds after grounding that the fuel gauge drops to empty. 6. If OK replace the Radio assembly. Programming is required after installation.