Razzi Front Install?

[whamslam3]

so eventually i want to get the razzi front splitter. i am worried about the install because i had a splitter on my car already and i hit it on something and it kind of tore the bottom of my front valance a little bit where the screws were on one side. so i am assuming this one will screw in that same area where i cant put a screw anymore so what can i do?

[zandron263]

When I attached mine there were 2 plastic L brackets that mounted inside the front wheel wells. The splitter screwed to those and the only other fastening was done with glue or double sided tape. There were no mechanical fasteners on the bottom. This was on the V6 bumper I don't know if it is different on the V8 bumper.

[whamslam3]

Originally Posted by zandron263

When I attached mine there were 2 plastic L brackets that mounted inside the front wheel wells. The splitter screwed to those and the only other fastening was done with glue or double sided tape. There were no mechanical fasteners on the bottom. This was on the V6 bumper I don't know if it is different on the V8 bumper.

o ok thanks sounds like it will be ok then

[chris1973]

Originally Posted by whamslam3

o ok thanks sounds like it will be ok then

I just installed my yesterday. He is correct. Also search the forums one DIY recommended (and did it) adding a screws or rivets underneath. I did the install with screws. Once everything was perfect I replaced the screws with pop rivets. You can get a rivet gun at any Home Depot or HW store for <$20.00.

Good luck.