Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Engine | Drivetrain | Powertrain Technical Discussions > V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6)


Reply
 
Thread Tools
Old 01-15-2018, 07:57 PM   #1
Abelardoo_12
 
Abelardoo_12's Avatar
 
Drives: 2011 camaro ss convertible
Join Date: Oct 2015
Location: Houston, tx
Posts: 371
Stabilitrak after truetrac and gear swap

This past weekend I had 3.91 gears installed along with a truetrac and put the diff back in the car. I had a new tune emailed to me for the gears as well. After all that when I went to start the car I had the stabilitrak message with all the traction control lights on including the ABS light. Has this happened to anyone else? Would it be a tune problem or something else? I checked for codes but there werenít any.
Abelardoo_12 is offline   Reply With Quote
Old 01-15-2018, 10:13 PM   #2
olblue75


 
olblue75's Avatar
 
Drives: 2010 2SS/RS
Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 4,196
Did you make sure all electrical connections are hooked up? Speed sensors at the hubs?
__________________
Orange Krush II
1LE Front sway bar with DSE Links, Splitter, 3.91 Gears and Axles, 14/15 Heat extractor, shocks and struts, Suede Flat bottom Steering wheel, short throw shifter with the Pegasus rear poly shifter mount, diffuser with dual mode mufflers, ZL1 Rockers, Belly Pan and pedals, Z/28 Intake, Headers, Cats,Toe Rods and UCA Bushings, 1 piece DSS Drive Shaft, C7 Z06 Vented Piston Calipers with CTS-V Rotors, PAFDT Solid Cradle bushing, 32mm JPSS Rear Bar, and Skip Shift eliminator. ASC race spec splitter and wicker. 6th Gen M017 Wheels.
olblue75 is offline   Reply With Quote
Old 01-16-2018, 05:48 AM   #3
Abelardoo_12
 
Abelardoo_12's Avatar
 
Drives: 2011 camaro ss convertible
Join Date: Oct 2015
Location: Houston, tx
Posts: 371
Quote:
Originally Posted by olblue75 View Post
Did you make sure all electrical connections are hooked up? Speed sensors at the hubs?
Yes I made sure everything was plugged in. I did stress the wheel speed sensor cable pretty good while trying to put the axle back in and then I decided to remove it but before reinstalling it I checked it and the cable looked good and didnít seem like it had any damage.
Abelardoo_12 is offline   Reply With Quote
Old 01-16-2018, 07:37 AM   #4
HOJO
 
HOJO's Avatar
 
Drives: 2014 Camaro SS/RS 1LE 1967 Camaro
Join Date: Oct 2013
Location: Fort Wayne, IN
Posts: 488
Not that I’m a mechanic by any means but a buddy of mine who is told me, if I remember correctly, that even if on wire inside going to the sensor breaks it will cause issues. Such as popping on lights indicating an issue. He said it causes a miss reading of the signal when a wire breaks. Hope this helps.
HOJO is offline   Reply With Quote
Old 01-16-2018, 07:52 AM   #5
ColdfuzionTN
 
Drives: 2012 Camaro SS
Join Date: Oct 2016
Location: Greeneville, TN
Posts: 143
What type of tune file was it as well, my money would be on the speed sensor as well but I'm sure someone here could look at the file quickly to rule the tune out. If its HpT I can look at it for you.
ColdfuzionTN is offline   Reply With Quote
Old 01-16-2018, 08:18 AM   #6
Abelardoo_12
 
Abelardoo_12's Avatar
 
Drives: 2011 camaro ss convertible
Join Date: Oct 2015
Location: Houston, tx
Posts: 371
Coldfuzion, thanks but I used an efi live autocal for the tune. I am going to replace the sensor later on today and see if that solves the issue and I’ll report back.
Abelardoo_12 is offline   Reply With Quote
Old 01-16-2018, 01:54 PM   #7
Abelardoo_12
 
Abelardoo_12's Avatar
 
Drives: 2011 camaro ss convertible
Join Date: Oct 2015
Location: Houston, tx
Posts: 371
So since I got sent home early from work due to weather, I took advantage and picked up a new sensor and swapped it out. No lights anymore and everything is back to normal.
Abelardoo_12 is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:50 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.