01-26-2020, 01:46 PM | #1 |
Bannable
|
Any upholstery guys in here?
Hoping someone here can give me some input. Drivers side seat leather on my new Supra pulls out of headrest piece. I'm hoping some steam or something will relax it enough to keep it from continuing. See picture.
__________________
One must forego the self to attain total spiritual creaminess, and avoid the chewy chunks of degradation
2017 ZL1 A10 - Hyper Blue Metallic Rotofab CAI, TM ported TB, AWE non res touring catback with PLP's |
01-26-2020, 04:29 PM | #2 |
Drives: 08 Tiburon GS, 2018 Camaro 2.0T Join Date: Sep 2017
Location: Québec
Posts: 1,657
|
Well if it is new, I'd say go to your dealer and have it fixed by them under warranty.
__________________
2018 Camaro LS | 6 spd | 2.0L turbo | Nightfall Grey | RS package | Technology Package.
--------------------- Order WDGHKX 1100 - 5/08/2018 | 3800 - 6/18/2018 2000 - 5/09/2018 | 4200 - 6/21/2018 3000 - 5/28/2018 | 5000 - 6/27/2018 6000 - 6/29/2018 |
01-26-2020, 06:48 PM | #3 |
Drives: 2017 Camaro ZL1 Coupe Join Date: May 2016
Location: Georgia
Posts: 5,811
|
I would run it back to the dealer too since it’s still under warranty!
__________________
ZL1 Coupe, PDR, Exposed carbon fiber hood insert, My Link with Nav, M6 6 speed and Silver Ice Metallic. Mods done: ceramic window tint, GM Accessories Camaro floor mats and Roto-Fab CAI.
|
01-26-2020, 07:40 PM | #4 |
|
Spent 11 years in upholstery.
I wouldn't heat it up, because that will make it expand. What you need is an upholstery regulator to feed it back in. Putting your left hand at the crease where it meets the stitching (opposite if your left handed), push the slack up, place the regulator in the center of the area that has come loose and feed it back under. I wish I was closer to you, I could do this is 5 minutes or less. This is an upholstery regulator. https://www.ebay.com/itm/141615087312 The tip on this tool is not sharp, it is rounded and wont damage the leather
__________________
Roto-Fab intake, SW 1 7/8" LT w/hi flow cats, Flowmaster outlaw exhaust, UDP, 160* stat, Circle D 3200, Moroso catch can, TCI line lock, Zex Nitrous 125 shot, 3.91 gear, Eaton True-trac, DSS 1000hp axles. |
|
|
Post Reply
|
|
|