07-20-2020, 07:19 PM | #1 |
Drives: 2014 Chevy Camaro 1LT Join Date: Mar 2020
Location: Normal IL
Posts: 3
|
HUD installation HELP!!!!!
Hello, I am attempting the HUD installation on my 2014 1LT. I purchased the harness from Gen5diy and I’ve followed the directions listed on this forum to a T but I noticed that no where in the instructions does it describe where I need to plug in this blue harness connector. It says I need to run the cables behind the dash and connect where the 4 gauge cluster is but I have nothing in that area that looks anywhere near like what this plug should connect to. Any advise would be greatly appreciated.
|
07-21-2020, 01:36 PM | #2 |
Drives: 2010 Camaro 2SS Join Date: Sep 2015
Location: Richmond Hill ,Ontario, Canada
Posts: 780
|
I have not done this myself but it looks like it may be an extra harness to connect to the 4 pack gauges that are mounted on the console at shifter. Maybe this description helps.
https://www.gen5diy.com/products/13-...ro-hud-harness |
07-21-2020, 01:50 PM | #3 | |
Drives: 2010 Camaro 2SS Join Date: Sep 2015
Location: Richmond Hill ,Ontario, Canada
Posts: 780
|
Yeah here it is sold separately
https://www.gen5diy.com/products/cop...-gauge-harness Passenger side kick panel location |
|
07-21-2020, 01:54 PM | #4 |
Drives: 2010 Camaro SS2,L99, LSA SC Join Date: Aug 2017
Location: Huntsville, AL
Posts: 2,155
|
Isn't that likely the gray wire in his picture above?
|
07-21-2020, 02:06 PM | #5 |
Drives: 2010 Camaro 2SS Join Date: Sep 2015
Location: Richmond Hill ,Ontario, Canada
Posts: 780
|
|
07-21-2020, 02:23 PM | #6 |
Drives: 2010 Camaro SS2,L99, LSA SC Join Date: Aug 2017
Location: Huntsville, AL
Posts: 2,155
|
|
07-21-2020, 11:07 PM | #7 |
Drives: 2014 Chevy Camaro 1LT Join Date: Mar 2020
Location: Normal IL
Posts: 3
|
Thanks for your help guys. I was able to find the connector on the passenger side footwell as suggested. You guys both ended up being right. The blue 30 pin adapter is installed in-line with the factory connector. The harness adds 2 black connectors for the hud and the hud controller and 1 grey connector for powering the 4 gauge cluster.
|
|
|
|
|