04-25-2020, 10:33 PM | #1 |
Drives: 2013 2SS/RS 1LE (6spd) Join Date: Mar 2018
Location: Temecula, CA
Posts: 281
|
Does this look right?
I am installing my LTH and hi flo but the connecting pipe to my NPP seems wrong to me. I cannot fit the pipe inside or over the exhaust. Does it just but up to each other and the clamp holds them? No exhaust leak?
__________________
CAI intake, Stainless Power LTH, SCT X4, NPP exhaust |
04-26-2020, 08:31 AM | #2 |
Drives: 2010 SS 2SS M6 Join Date: Aug 2016
Location: Smithsburg, Md.
Posts: 2,445
|
yup...just get it centered on the joint before tightening.
Good luck! PEACE
__________________
2010 SS 2SS M6 - Tune by RDP dynoSteve!(Woot) - Daily Driver - 150K! - All work by me...
|
04-26-2020, 08:33 AM | #3 |
Drives: 2010 ss/rs 6 speed manual Join Date: Aug 2013
Location: Ny
Posts: 584
|
Yes that clamp should fit over both pipes and hold it together. That is how my exhaust was held together when I put on my exhaust. As far as leaks go I’m not 100% on reusing the clamps I’m not a mechanic or exhaust expert. But I reused mine and don’t notice any leaks from mine.
__________________
2010 camaro ss/rs, standard 6 speed, ls3 motor, bmr subframe connectors, jba 3” competition Exhaust, stainless works 1 7/8" headers, adm cold air intake, hurst short throw shifter, bo white ported tb, mishimoto aluminum radiator, mishimoto oil cooler.
|
04-26-2020, 09:17 AM | #4 |
Drives: 2013 2SS/RS 1LE (6spd) Join Date: Mar 2018
Location: Temecula, CA
Posts: 281
|
Ok thank you so much
__________________
CAI intake, Stainless Power LTH, SCT X4, NPP exhaust |
04-28-2020, 07:36 AM | #5 |
sean121
Drives: Chevrolet Bolt. 2017 Join Date: Apr 2020
Location: Denver, Colorado
Posts: 5
|
It should fit right in. Everything looks good to me.
|
05-06-2020, 11:55 AM | #6 |
Drives: 2013 2SS/RS 1LE (6spd) Join Date: Mar 2018
Location: Temecula, CA
Posts: 281
|
it did in fact fit over both pipes and just clamp them together. Nothing goes in or over at the exhaust side, just the header to cat side
__________________
CAI intake, Stainless Power LTH, SCT X4, NPP exhaust |
05-06-2020, 10:17 PM | #7 |
Banned
Drives: 2015 Camaro Join Date: Aug 2018
Location: My Garage
Posts: 1,125
|
When you get it smogged, do you have to take everything apart again?
|
05-07-2020, 04:11 PM | #8 |
Drives: 2013 2SS/RS 1LE (6spd) Join Date: Mar 2018
Location: Temecula, CA
Posts: 281
|
sure do!
__________________
CAI intake, Stainless Power LTH, SCT X4, NPP exhaust |
|
|
|
|