10-30-2018, 10:45 PM | #1 |
Drives: 2010 Cadillac cts4 wagon 3.6 Join Date: Sep 2017
Location: Columbia TN
Posts: 21
|
Fuel rail and injector install
So I’m in the process of doing a supercharger install. Got the old injectors out. Got the driver side in. Can not get the passenger side to rotate enough to go into place. I’m hitting on what I’m guessing is a water jacket on the front of the engine. What am I missing? There’s got to be some secret or technique I’m missing. Any help?
Sent from my iPhone using Tapatalk |
11-07-2018, 08:24 PM | #2 |
Drives: 2010 Camaro 2LT V6 Join Date: Jul 2009
Location: California
Posts: 439
|
Hi Backon4,
I just recently replaced my injectors (150k on the originals). On the passenger rail, it was much easier to put back in by first taking off the fuel pressure sensor located on the front of the passenger side rail. I used a deep socket to take it out. Everything was smooth once I figured that out. Also, make sure the plastic collars that snap around the injectors are in place. Bonus tip, be sure to put a dab of motor oil on the injector gaskets, helps lubricate them and allows for the rails to easily pop on and avoid shearing the rubber seals.
__________________
Injen CAI, V-Max Throttle Body, Rx 25mm Iceolator, Rx 10mm Plenum Spacer, Mace Ported Manifold, ARK N-II Catback, Trifecta Tune, Rx Catch Can.
BMR Bushing Inserts,Pedders Radius Rod Inserts, Pfadt Sway Bars and Endlinks, LSR Front Subframe Brace SS Brembo Brakes, Racing Brake Stainless Lines |
|
|
|
|