11-11-2017, 09:31 AM | #1 |
Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Which way does MAF face???
Doing a swap and putting a 2015 LFX into my Scion FRS. That said,, just got the MAF sensor and not sure which way it faces. I would assume the opening faces into the air stream but not sure.
Can someone confirm?? |
11-11-2017, 07:28 PM | #2 |
|
The way it's oriented in the picture is the same way it's mounted in my Cold air intake. To answer your question ,yes.
__________________
Mods, K&N CAI ,VTC , GM Perf Axleback Exhaust, Elite Eng CC and CSS, GM Strut Tower Brace,Carbon Fiber Anvil Spoiler,ASC T5 Splitter,Gen5diy Foglight kit.
|
11-12-2017, 07:44 AM | #3 |
Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Thanks!!!!!!
|
11-14-2017, 02:29 PM | #4 |
Drives: 2012 45th Anniversary Edition Join Date: Aug 2012
Location: San Diego, CA
Posts: 1,618
|
Plus, i think the holes are oriented in the tube for it to fit only one way
|
12-20-2017, 12:18 PM | #5 |
Drives: 2012 Camaro RS 2LT 6spd man Join Date: Aug 2013
Location: Dickinson, Texas
Posts: 535
|
I think there is an arrow on the part orienting the way it's supposed to be installed.
|
12-20-2017, 12:24 PM | #6 |
Instagram: Sangstah
|
whoa sounds like a unique build, any photos?
__________________
2019 SS 1LE - "CaSSandra" 2014 SS - "AleSSandra - Sold" 94 Z28 - Sold
Follow the build https://www.camaro6.com/forums/showthread.php?t=612717 |
12-21-2017, 09:35 AM | #7 |
Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Build thread is here.
http://www.ft86club.com/forums/showthread.php?t=117334 Should scoot pretty good when done,, FRS is 2750 Lbs so quite a bit lighter than a Camaro. Biggest issue has been with the FRS's rear cross member. Had to get an Oil pan from a Holden out of AU. Also had to recess the clutch master 2 3/4" into the firewall to clear the HP pump on the motor. Motor mounts are done,,, starting transmission mounts and exhaust systems now. |
|
|
|
|