08-21-2020, 01:48 PM | #1 |
Drives: Black 2015 Z28 #457 Join Date: Sep 2016
Location: Dallas, TX
Posts: 214
|
Flare and side sill removal
OK group, so I'd like to remove the side sills/skirt and clean them up a bit and re-affix two of my flares. However once I get the 4 screws holding each sill/skirt off, there appear to still be some clips holding the sills in place. Unfortunately I can't tell where the clips are to remove them, anyone got any pointers?
Thanks! Mark |
08-22-2020, 12:27 AM | #2 |
Drives: 2010 2SS/RS Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 6,064
|
If I remember all my reading they are held on with a special two side tape nit general 3M tape an it also takes a special primer as well on reinstall again if memory serves.
__________________
Orange Krush II
1LE Front sway bar, Splitter, shocks and struts, Z28 dual mode mufflers, Intake, UCA Bushings, and Toresen 3.91 Diff. 1 piece DSS Drive Shaft, ZL1/C7 Calipers, and 32mm JPSS Rear Bar. ASC race spec splitter and wicker. 6th Gen M017 Wheels. Stainless Works 1 7/8 LTs. DSE and PAFDT Suspension components. |
08-25-2020, 10:13 AM | #3 |
Drives: 2015 Z/28 #1251 Join Date: Sep 2015
Location: AR
Posts: 72
|
|
08-25-2020, 10:30 AM | #4 |
Drives: 2015 1SS 1LE Join Date: Jul 2020
Location: SE Minnesota
Posts: 46
|
Preliminary Procedure
Open the door on the side the lower rocker molding is being serviced. Remove the rear wheel and tire assembly on the side the rocker molding is being serviced. Refer to Tire and Wheel Removal and Installation. 1 Front Wheelhouse Panel Liner Screw (Qty: 2) Caution: Refer to Fastener Caution. 3 Nm (27 lb in) 2 Rear Wheelhouse Panel Liner Screw (Qty: 2) Caution: Refer to Fastener Caution. 3 Nm (27 lb in) 3 Lower Rocker Molding W-Clip (Qty: 6) Procedure Use a trim-type release tool in order to disengage the w-clips from the lower body panel. 4 Front Fender Upper Flange W-Clip (Qty: 2) 5 Rear Bodyside Panel W-Clip (Qty: 3) 6 Door Opening Sill Panel W-Clip (Qty: 7) 7 Rocker Panel Molding Procedure Transfer the front side door lower auxiliary weatherstrip to the New rocker molding. Install New w-clips if any are damaged or broken after the rocker molding has been removed. Note: A small trim type release tool is necessary for removal of the weatherstrip retainers. From ALLData |
|
|
|
|