12-12-2017, 01:34 PM | #43 | |
Drives: 2015 Z28 Join Date: Jul 2011
Location: Vista, CA
Posts: 127
|
Quote:
No harness needed. They have the simulators with the plugs built onto them. I emailed a picture of the vehicle harness plugs for each of them. They built them to order. Last edited by LeftCoast32; 12-12-2017 at 01:49 PM. |
|
12-12-2017, 01:49 PM | #44 | |
Drives: 2010 Camaro 2ss/Rs Transformers Join Date: Aug 2014
Location: Yorba Linda, California
Posts: 1,564
|
Air bag bypass for new seat
Quote:
The harness plugs you sent them pics of were the ones on the bottom of the stock seats and one inside the car where the stock seats go? Here’s a pic of what they told me they could do. Did you have to reuse harnesses from your old seats? That’s what they told me to do, but I haven’t had time to remove the harnesses and wiring and module from my old seats yet.
__________________
YouTube:Krisprz garage
Insta:kris__perez & krisprz_garage LS3 conversion Vararam intake(tune model) Kooks LT headers & cats delete Corsa ZL1 3" exhaust RedBarn Racing Tune CMS Stage 3 Cam AFR CNC ported heads MSD Spark plug wires LNC-2000 Launch controller NGK TR6 Spark Plugs 1le strut tower brace-TPIS spacers Nick Williams 102mm throttle body Fast lsxr 102 intake manifold Slp 25% UDP Katech Tensioner Pulley Circle D 3600-3700 multi disk Stall GM 3.91 gears DDS carbon fiber driveshaft ZL1 fuel pump & injectors Flex fuel sensor(91/E85) https://wheelwell.com/kris-perez |
|
12-12-2017, 01:52 PM | #45 |
Drives: 2015 Z28 Join Date: Jul 2011
Location: Vista, CA
Posts: 127
|
I modified the factory seats and retained the seat harness. The pics were of the plugs that the airbags plug into.
|
12-12-2017, 02:34 PM | #46 |
Drives: 2015 Z28 Join Date: Jul 2011
Location: Vista, CA
Posts: 127
|
|
02-12-2018, 03:24 PM | #47 | |
Drives: 2014 Z/28 #82+#192, 18ZLE 66Nova Join Date: Oct 2008
Location: By the lake in AZ
Posts: 15,719
|
Quote:
|
|
12-26-2022, 02:59 PM | #48 |
Drives: Camaro 5th gen Join Date: May 2019
Location: New york
Posts: 3
|
From what I read the 2010-2011 have a different harness and a sensor that was not in later models. Also from what I read is you only need a 2.1 - 4 ohm resistor that goes between the yellow wire with black tracer to the brown wire that run to the airbag plug/sensor. I have read basically all the forum posts on this and no one has posted anything with good detail on the procedure. Maybe when my stuff shows up ill try and document how to install a driver side seat on a 2010.
|
12-27-2022, 12:26 AM | #49 |
Drives: 2014 Z/28 Join Date: Jul 2022
Location: CA
Posts: 87
|
|
|
|
|
|