02-22-2020, 07:03 PM | #1 |
Drives: Camaro LT 2012 Join Date: Jan 2020
Location: New York
Posts: 30
|
Blade Arm PROBLEM Help
Guys,
I had to pull of my blade arms - and put them back - when I did it - driver side went down to "ruber" - but passanger side looks like this - should this go futher down so we can't see a nut? Thanks! PS. Pulling wind blades was a DRAG. |
02-23-2020, 09:18 AM | #2 |
Drives: Camaro LT 2012 Join Date: Jan 2020
Location: New York
Posts: 30
|
Anybody?
|
02-23-2020, 11:14 AM | #3 |
Drives: 2014 2SS/RS Join Date: Dec 2014
Location: Raleigh, NC
Posts: 1,054
|
Mine on passenger side is all the way down to the rubber. Did you accidentally push the rubber grommet in? Did you take stress off the wiper arm by putting it in the service position when aligning it on post? First photo is upside down, had camera flipped to get in there.
__________________
2014 2SS/RS, Z28 CAI and High Wing Spoiler, ZL1 5.1:1 Ratio Short-Throw Shifter, ZL1 Pedals, ZL1 splash guards, NPP Dual-mode quad tip exhaust, Z28 strut tower brace, Camaro LED Cup-holders with footwell Lighting option, Leather visors, and Leather E-brake boot. Chevy dealer sponsored 67 retro SS nose stripe package.
Last edited by ron123; 02-23-2020 at 01:40 PM. |
02-23-2020, 05:20 PM | #4 | |
Drives: Camaro LT 2012 Join Date: Jan 2020
Location: New York
Posts: 30
|
Quote:
Thanks for photo! I appreciate it! You might be right... i might push down by acident rubber down... Will check it again! |
|
02-23-2020, 07:00 PM | #5 | |
Drives: Camaro LT 2012 Join Date: Jan 2020
Location: New York
Posts: 30
|
Quote:
Hey! You were right - its rubber fault! Thanks again! |
|
02-24-2020, 05:39 AM | #6 |
Drives: 2011 RS Join Date: Jun 2018
Location: Coldwater Mi
Posts: 175
|
Let's put the blame where it belongs: USER fault, not rubber fault!!
__________________
Proud Owner Of '11 Camaro
|
02-25-2020, 09:59 PM | #7 |
Drives: Camaro LT 2012 Join Date: Jan 2020
Location: New York
Posts: 30
|
|
|
|
Thread Tools | |
|
|