09-30-2010, 09:52 AM | #15 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Thanks, going to take the outdoor shots today after the alignment.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
09-30-2010, 06:14 PM | #16 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
More pictures, don't forget to rate this page.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-02-2010, 09:08 PM | #17 | |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Guys, check out my suspension cam from today's Auto-X event. I have aftermarket front and rear sways, lowering springs, sub frame connectors and trailing arms. That one rear end bushing sure moves a lot. I need to upgrade it big time. Note the movement on the stock tires, they were filled at 39 PSI, I'm going to go with 40 PSI tomorrow.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
|
10-02-2010, 09:29 PM | #18 |
Tampa Gulf Coast Family
|
WOw. Nice build!
__________________
|
10-05-2010, 08:00 AM | #19 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Just purchased the Spohn Polyurethane Bushing Kit for Rear Differential to Rear Cradle Mounts. This should make a big difference in the rear. I will post some before and after videos.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-05-2010, 08:06 AM | #20 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Autocross event in Santa Clara this last weekend. The car performed very well.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-09-2010, 08:00 PM | #21 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
BMR Fabrication Review:
I have the strut brace, driveshaft safety loop, subframe connectors and lowering springs. I will start out by saying that I'm very disappointed with the BMR customer service. It takes forever if you are lucky enough to get a response to a technical question email. The springs did not come with instructions so I had to use the PFADT instructions. The subframe connectors only work with their tunnel brace, unless you are able to modify your OEM or aftermarket one. There was no mention of the tunnel brace fit until after I ordered it and they offered to sell me theirs. Theirs looks good if you haven't already purchased one from another vendor. I was able to make mine work after cutting it down with my chop saw. You don't want to have to cut it by hand. I pulled the strut brace off after I noticed that the collars were shifting all over the place when turning the steering wheel after installed. I went back to stock and sent two emails and a couple of calls for technical assistance over a week ago and have yet to hear back. The spring kit was missing two parts, BMR did ship them out to me right away after I was able to contact them for those the first day of install. BMR has some nice items, I doubt that I will be a future customer again because of their poor customer service. My reviews on the items I purchased. The springs dropped my car nicely and I'm happy with them. There are no noises coming from them. The subframe connectors installed ok after I modified the tunnel brace. I would recommend that you purchase one from them for correct fit if you choose to go that rout. Most including vendors will tell you that our cars don't need them. I auto-x my car and want all the stiffness that I can get. Hard to say if they help me since I didn't take before and after videos. I would be glad to take some after video of any portion of the underside of the car for those who would like to compare before and after results. The strut tower was removed as noted below. It looks great, just don't think or know if the fastener rings should move like that and I don't want to take that chance since my car gets driven really hard through the auto-x courses. The drive shaft safety loop looks heavy duty. You will need one of these if you plan on running sub 13s in the quarter mile. The install is a bit tough with the exhaust in the way, but doable with patience.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-10-2010, 11:09 PM | #22 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Ran my first SCCA autocross event today. The course was tougher then the AAS courses I have run, but not as tight as I expected it to be.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-12-2010, 07:30 AM | #23 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Some pictures from last Sunday's autocross event.
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-12-2010, 09:48 PM | #24 |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
More autocross pictures
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
10-17-2010, 03:24 PM | #25 |
MONGOOSE
Drives: 2011 SS Camaro M6 Join Date: Sep 2010
Location: Buford, GA
Posts: 178
|
Car looks good! Our cars look nearly identical. It is cool to see someone else with the Hockey Stick stripes. Sorry to hear about all of your problems with the BMR stuff. I am taking my car in the same intended direction as yours. I'm looking into using the Pfadt components or the Pedders stuff. What size drag radials did you put on the car and what were your 60ft times like? If you get a moment check out my journal on the Mongoose - I just started it this weekend.
|
10-17-2010, 11:11 PM | #26 | |
Prefer to be blown!
Drives: 2010 Silver/Black 2SS/RS Manual Join Date: Mar 2010
Location: Nor-Cal
Posts: 2,677
|
Quote:
__________________
MagnaCharger TVS-2300 550rwhp 540 rwt and a radical suspension under the car.
|
|
10-17-2010, 11:27 PM | #27 |
E.B.A.H.
Drives: you wild... Join Date: Mar 2007
Location: In the happy padded room wearing a jacket that makes me hug myself...
Posts: 18,421
|
Nice pics of your runs Steve. Gotta upload the gopro videos too though.
Keep up the good work and eventually I'd love to head to a track and run with ya. |
10-17-2010, 11:37 PM | #28 |
|
Steve,
Wow your car looks great. Keep us up-to-date with the upgrade on the mods. What engine mods are you looking to do?
__________________
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
THE OFFICIAL NY THREAD | DON_RAFA | USA - NY / NJ / PA | 536 | 05-02-2021 09:14 AM |
Torque Converters | CamaroSpike23 | V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) | 48 | 08-16-2014 02:07 AM |
2SS SILVER ICE 6 SPEED AVIALABLE | 1badss | USA - Southcentral | 0 | 10-03-2009 02:06 PM |
PADDOCK CHEVROLET $500 BELOW MSRP PLUS UP TO $1000 IN REBATES!!!!!! | 454chevelle71 | Dealer Camaros for Sale | 47 | 10-01-2009 10:47 AM |
2010 2SS/RS 6 Speed Black FS in Texas | F-MAN-SS | Autos For Sale / Wanted | 2 | 08-05-2009 07:04 PM |