Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > CAMARO6.com General Forums > 2016+ Camaro: 6th Gen Camaro general forum


Phastek Performance


Post Reply
 
Thread Tools
Old 10-20-2016, 03:13 PM   #1
NY Andrew
 
NY Andrew's Avatar
 
Drives: 2016 Camaro V6 2LT RS Fully Loaded
Join Date: Sep 2015
Location: VA
Posts: 474
Question Hood flush or dipped a little beneath front body?

Not sure if my hoods messed up from my horrible recent experience bringing it in for service, but my hood now sits NOT flush but a little lower say 1/2" below the front body all along the side of the hood until it gets about half way up then it's flush again.. is everyone's like this or is mine messed up? Don't recall it ever being like this you can notice it and feel it. Hard to get a picture of it.. tried to mess with it but the locking mechanism is really that low so it's gotta hug it down there not sure what's up. Thanks.
__________________
Borla ATAK w/ Midpipe, VMAX TB, K&N Filter, Subwoofer, Tinted, AFM Disabler, Vitesse Throttle Controller!
ORDERED:08/19/15 DELIVERED:12/09/15
My 2LT Review/Pictures/Mustang Comparison
My 2016 Camaro Bose Subwoofer Install
2016 Camaro V6 Stock to Borla Atak Exhaust Sound
2016 Camaro V6 Resonator & X-Pipe Replace with Midpipe & Borla Atak
NY Andrew is offline   Reply With Quote
Old 10-20-2016, 03:16 PM   #2
Eric SS
#becauseracecar
 
Eric SS's Avatar
 
Drives: 2016 SS Sedan, 2016 Camaro SS
Join Date: May 2015
Location: Phoenix
Posts: 2,959
1/2"? Is that hyperbole or is it really 1/2" off? That's a huge amount and not normal. Do you have a photo?
Eric SS is offline   Reply With Quote
Old 10-20-2016, 03:56 PM   #3
SS 1LE
マスタング = 遅い
 
SS 1LE's Avatar
 
Drives: 2017 Chevrolet Camaro SS 1LE
Join Date: Aug 2015
Location: Florida
Posts: 7,061
You can adjust that with the rubber stoppers in about 5 minutes in most cases if it's what I think you're describing...
__________________
SS 1LE is offline   Reply With Quote
Old 10-20-2016, 04:01 PM   #4
TrickracenLS3
 
TrickracenLS3's Avatar
 
Drives: 2016 Camaro 2SS Red Hot
Join Date: Dec 2014
Location: San Fernando Valley, CA
Posts: 476
__________________
1989 Iroc-Z Z28 1LE/HP (Sold)
2010 2SS Rally Yellow: Corsa/Vararam (Sold)
Current: 2016 Camaro 2SS Red Hot
Current: 2016 Tahoe LT
Current: 2018 Mini Countryman S
TrickracenLS3 is offline   Reply With Quote
Old 10-20-2016, 04:11 PM   #5
SpookShow'84
Bump in the night
 
SpookShow'84's Avatar
 
Drives: '84 Monte Carlo SS, '15 Optima
Join Date: Oct 2015
Location: U.S.A.
Posts: 744
+1 for what SS 1LE said.

I'd think you would have to have frame damage for it to not adjust out with the stops, being that the back is decently flush. Is there a visible crease or bend point in the hood?
__________________
SpookShow'84 is offline   Reply With Quote
Old 10-20-2016, 04:24 PM   #6
NY Andrew
 
NY Andrew's Avatar
 
Drives: 2016 Camaro V6 2LT RS Fully Loaded
Join Date: Sep 2015
Location: VA
Posts: 474
To the smart asses asking for pics the pics don't do it any justice at all it doesn't get the angle right!! But thank you I didn't know the stoppers adjusted!! I guess just twist rotate them? I'll have to try that later and see if it works.
__________________
Borla ATAK w/ Midpipe, VMAX TB, K&N Filter, Subwoofer, Tinted, AFM Disabler, Vitesse Throttle Controller!
ORDERED:08/19/15 DELIVERED:12/09/15
My 2LT Review/Pictures/Mustang Comparison
My 2016 Camaro Bose Subwoofer Install
2016 Camaro V6 Stock to Borla Atak Exhaust Sound
2016 Camaro V6 Resonator & X-Pipe Replace with Midpipe & Borla Atak
NY Andrew is offline   Reply With Quote
Old 10-20-2016, 04:27 PM   #7
SpookShow'84
Bump in the night
 
SpookShow'84's Avatar
 
Drives: '84 Monte Carlo SS, '15 Optima
Join Date: Oct 2015
Location: U.S.A.
Posts: 744
Don't get bent out of shape, it's just that a 1/2" is a lot in terms of hood alignment.
__________________
SpookShow'84 is offline   Reply With Quote
Old 10-20-2016, 04:30 PM   #8
BowtieRocket

 
BowtieRocket's Avatar
 
Drives: 2016 Camaro 2SS- M6
Join Date: Sep 2016
Location: Albuquerque
Posts: 1,133
I adjusted mine after buying...flush now and tight enough that hood doesn't shake as much at speed.
__________________
2016 Camaro 2SS M6- Garage
BowtieRocket is offline   Reply With Quote
Old 10-20-2016, 04:40 PM   #9
Eric SS
#becauseracecar
 
Eric SS's Avatar
 
Drives: 2016 SS Sedan, 2016 Camaro SS
Join Date: May 2015
Location: Phoenix
Posts: 2,959
Quote:
Originally Posted by NY Andrew View Post
To the smart asses asking for pics the pics don't do it any justice at all it doesn't get the angle right!!
Way to be a jackass to people just asking to see what yours looks like to compare it to ours...
Eric SS is offline   Reply With Quote
Old 10-20-2016, 06:08 PM   #10
Number 3
Hail to the King baby!
 
Number 3's Avatar
 
Drives: '19 XT4 2.0T & '22 VW Atlas 2.0T
Join Date: Dec 2008
Location: Illinois
Posts: 12,170
1/2 inch is VERY large. So large that it would easily show up in a picture. If it's a half inch off and you jack the bumpers up to try and flush it up, you could cause damage to the aluminium hood.

1/2" is the latch being off.
__________________
"Speed, it seems to me, provides the one genuinely modern pleasure." - Aldous Huxley
Number 3 is offline   Reply With Quote
Old 10-20-2016, 06:32 PM   #11
TSloper

 
Drives: 2016 Camaro SS
Join Date: Jan 2016
Location: Mount Dora, FL
Posts: 779
I'm sure to some wives out there 1/2" would be a significant amount.
TSloper is offline   Reply With Quote
Old 10-20-2016, 06:33 PM   #12
JeffPA2ss
 
JeffPA2ss's Avatar
 
Drives: 2016 Camaro 2SS Summit White
Join Date: Jun 2016
Location: Canonsburg, PA
Posts: 37
Quote:
Originally Posted by Eric SS View Post
Way to be a jackass to people just asking to see what yours looks like to compare it to ours...
+1 Exactly.

OP comes on here and says that the hood is a half inch off...a half inch is HUGE. So either OP is exaggerating or has a serious problem. Either way, pictures would answer which it is...
__________________
2016 2SS, Summit White, Adrenaline Red Seats and Accents, NPP, Red Rally Stripes, Red Knee Pads, Black Bow Ties, Black Front Fascia Extension, Black Splash Guards, Black/Red Shifter Bezel
JeffPA2ss is offline   Reply With Quote
Old 10-20-2016, 07:10 PM   #13
NY Andrew
 
NY Andrew's Avatar
 
Drives: 2016 Camaro V6 2LT RS Fully Loaded
Join Date: Sep 2015
Location: VA
Posts: 474
Here's the pictures. Looks better at night than day time to see the difference but tried adjusting the bumpers (all 4 of them) which didn't fix the issue..
Attached Images
    
__________________
Borla ATAK w/ Midpipe, VMAX TB, K&N Filter, Subwoofer, Tinted, AFM Disabler, Vitesse Throttle Controller!
ORDERED:08/19/15 DELIVERED:12/09/15
My 2LT Review/Pictures/Mustang Comparison
My 2016 Camaro Bose Subwoofer Install
2016 Camaro V6 Stock to Borla Atak Exhaust Sound
2016 Camaro V6 Resonator & X-Pipe Replace with Midpipe & Borla Atak
NY Andrew is offline   Reply With Quote
Old 10-20-2016, 07:30 PM   #14
SSSHYBOY
 
Drives: 2SS convertible, black,black
Join Date: Apr 2016
Location: Glendale, Ca
Posts: 450
Simple answer.... Drive to dealer and look at others... Than see the service manager.
__________________
A little known fact. Women with extra pounds, tend to live longer than men who mention it.
SSSHYBOY is offline   Reply With Quote
 
Post Reply

Tags
hood


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:21 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.