12-20-2018, 04:27 PM | #1 |
6th Gen shifter on 5th gen?
Hey guys, so my shift knob on my 1le has gone to shit...again.. and I was wondering if there is any way the 6th gen shift knob and boot possibly would fit on ours. Pics below.
__________________
Work hard, play harder
Last edited by Ashn_G_1LE; 12-21-2018 at 02:04 PM. |
|
12-20-2018, 09:14 PM | #2 |
Tri-County Camaro SWFL
|
From what I've seen, the set screw that holds the knob on, 6th gen is on the left, 5th is on the right. The set screw just hits the metal shaft so it a possibility it would fit. I'm not sure if the little plastic ring would snap back up. You may be able to make it would if you did the 6th gen boot and knob reusing the 5th gen plastic that holds the boot.
I upgraded to a MGW when my OE knob got messed up. I had the race knob and ended up liking the ball better for daily driving.
__________________
Last edited by CamaroDreams76; 12-20-2018 at 09:24 PM. |
12-21-2018, 01:49 PM | #3 | |
Quote:
__________________
Work hard, play harder
|
||
12-21-2018, 07:39 PM | #4 |
Tri-County Camaro SWFL
|
I watched these two videos to make my conclusion
For 2013+ https://youtu.be/iR45CGOnQOo For 6th gen https://youtu.be/B3pRmemSwzc
__________________
|
|
|
Thread Tools | |
|
|