DIM HID headlight replacements SOLUTION - Page 2 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

anthony.martinez · 12-05-2018, 08:22 AM

The alignment we fairly easy. Before I mounted the projectors to the brackets, I measured the old one so that I could get the center of the eye in the correct place in relation to the bracket. After doing so I drilled some new holes to screw the projector to the bracket. You have to take the head light assembly apart so that you can fit the new eye to the existing shroud. Once all that was put together all I had to do was just adjust them with adjuster screw for height.

camguynj · 12-05-2018, 11:22 AM

Quote:

Originally Posted by anthony.martinez

The alignment we fairly easy. Before I mounted the projectors to the brackets, I measured the old one so that I could get the center of the eye in the correct place in relation to the bracket. After doing so I drilled some new holes to screw the projector to the bracket. You have to take the head light assembly apart so that you can fit the new eye to the existing shroud. Once all that was put together all I had to do was just adjust them with adjuster screw for height.

Very smart to measure the old center location first ! Is the adjustment made from inside the projector assembly or on the outside ?

anthony.martinez · 12-05-2018, 11:37 AM

Before I sealed my headlight assemblies I mounted them to the car and made sure my cut off lines were horizontally straight. Once I verified that I sealed them and then mounted them back on the car and made my height adjustment on the outside adjuster bolt. The only thing I should have done was; wait for the 5.0's to be released. the output proved to be a brighter.

12-05-2018, 08:22 AM	#15
anthony.martinez Drives: 2010 Join Date: Dec 2018 Location: texas Posts: 119	The alignment we fairly easy. Before I mounted the projectors to the brackets, I measured the old one so that I could get the center of the eye in the correct place in relation to the bracket. After doing so I drilled some new holes to screw the projector to the bracket. You have to take the head light assembly apart so that you can fit the new eye to the existing shroud. Once all that was put together all I had to do was just adjust them with adjuster screw for height.

12-05-2018, 11:37 AM	#17
anthony.martinez Drives: 2010 Join Date: Dec 2018 Location: texas Posts: 119	Before I sealed my headlight assemblies I mounted them to the car and made sure my cut off lines were horizontally straight. Once I verified that I sealed them and then mounted them back on the car and made my height adjustment on the outside adjuster bolt. The only thing I should have done was; wait for the 5.0's to be released. the output proved to be a brighter.