07-26-2019, 09:13 PM | #1 |
Drives: 2013 1SS BlueRay Metallic Join Date: Nov 2018
Location: Missouri (MO)
Posts: 163
|
2013 rear bowtie and SS removal
Anyone have any tips on getting the adhesive off. I got my side badges off clean and smooth. The rear bowtie and SS left like adhesive smears and I can see the outline of where they were. My only guess is they were done in the colder months and then left sitting until it warmed up outside and just never came clean for me. I've used goof gone and wd40 and it's been little results.
|
07-29-2019, 10:21 AM | #2 |
Drives: 2010 Camaro 2SS/RS Black & Silver Join Date: Aug 2010
Location: Richmond, VA
Posts: 8,228
|
I used the 3M adhesive remover wheel. Works great!
__________________
STAINLESS WORKS HEADERS-TUNED BY JANNETTY RACING-C.A.I. INTAKE-TAYLOR 409 WIRES-SOLO AXLE BACK EXHAUST-ELITE CATCH CAN |
07-29-2019, 05:28 PM | #3 | ||
|
For adhesive residue I haven't found anything better than Rapid Tac Rapid remover.
The outline you see is probably not residue, it's call "ghosting". This occurs when a badge or decal is removed, revealing the paint that has had no UV exposure due to being covered. Polishing is the only way to remove it.
__________________
Roto-Fab intake, SW 1 7/8" LT w/hi flow cats, Flowmaster outlaw exhaust, UDP, 160* stat, Circle D 3200, Moroso catch can, TCI line lock, Zex Nitrous 125 shot, 3.91 gear, Eaton True-trac, DSS 1000hp axles. |
||
|
|
|
|