Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Cold Air Inductions
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Engine | Drivetrain | Powertrain Technical Discussions > Forced Induction - V8


Reply
 
Thread Tools
Old 05-13-2010, 11:47 PM   #29
TeddyP25
 
TeddyP25's Avatar
 
Drives: 2SS
Join Date: May 2009
Location: Fort Collins
Posts: 611
Stock pump and didnt have any kind of drop off. The pulley is one size smaller than the kit comes with, it was 3.25
__________________
2SS/RS CGM/BLK GFX MN6418 Stroker.785rwhp/885lbtq.50 SHOT NO2..Pfadt arms,toe links,coilovers,swaybars,end links,engine mounts,dif/sub bushings.MGWshifter.Tick LVL 3.ARH1 7/8 LT's/ARH exhaust.ADM gauges/race CAI.E-FORCE SC.8 rib IW 10%OD.LPE dual pump/module.85lb inj,custom valve covers.RMCR tune.TOOLEY RACING CAM.JRE posi kit.JRE fuel upgrade.RX MONSTER CatchCan.DSS axels/DS.Hammerhead rear, 3:73's. WYOSPEED builthttp://www.camaro5.com/forums/showthread.php?t=115687
TeddyP25 is offline   Reply With Quote
Old 05-14-2010, 07:11 AM   #30
Z_Rocks

 
Z_Rocks's Avatar
 
Drives: everyone crazy...
Join Date: May 2009
Location: SW Florida
Posts: 2,108
Quote:
Originally Posted by RMCR View Post
The valley cover was miss-machined on the oil level sender. They did not tap it enough for a proper seal on the crush collar. We actually had to bore out the hole more and retap the threads. It visually looked fine was only off just a little but was enough to to cause a drastic leak.

For anyone else installing this kit I would check that the sender seats fully on the crush collar. Other than that it was a great and simple kit to install.

As far as the IAT I will check my logs tomorrow. The only other bummer was they sent coil covers for a C6 Corvette. We are still waiting on the right ones.

These #'s are SAE corrected so these #'s should be the same anywhere in the country.

Thanks for all the reply's.
Mike, your shop seem to do real nice, "No matter" which kit!
Z_Rocks is offline   Reply With Quote
Old 05-14-2010, 07:58 AM   #31
Mike@RMCR
 
Mike@RMCR's Avatar
 
Drives: Supercharged
Join Date: Oct 2009
Location: Colorado Springs
Posts: 314
Quote:
Originally Posted by PJ droopy pants View Post
Hi RMCR, awsome numbers!
Are you running a stock fuel pump? And is the one size smaller pully the 3.5"?
At our altitude a fuel upgrade is not necessary. If we were at sea level I would recommend a minimum of a booster pump or a twin setup.

Hope this helps.
Mike@RMCR is offline   Reply With Quote
Old 05-14-2010, 08:32 AM   #32
2010 SSRS



 
2010 SSRS's Avatar
 
Drives: 3 V8 Camaros
Join Date: May 2009
Location: The Ocean State
Posts: 111,204
nice
__________________
Jannetty Racing JRE Street Package
2010 SSRS is offline   Reply With Quote
Old 05-14-2010, 01:09 PM   #33
victoryred1ss
 
victoryred1ss's Avatar
 
Drives: 2010 SS M6 2016 2SS A8
Join Date: Oct 2009
Location: Utah
Posts: 553
Very nice numbers TeddyP!
__________________
TVS 2300 721RWHP 686RWTQ
Built by Me
Suspension done by JDP
Tune done by JRE
victoryred1ss is offline   Reply With Quote
Old 05-14-2010, 01:23 PM   #34
KILLER74Z28
MOD SQUAD
 
KILLER74Z28's Avatar
 
Drives: 2G1FT1EW9A9100666
Join Date: Aug 2006
Location: West Michigan
Posts: 5,767
Any video of this bad boy??? Street/Dyno etc...
__________________

Who cares about the Blue Oval crowd and their little Ponys? We're getting our Camaro back-and it'll be Supercharged!-MDAII
Team LS3
KILLER74Z28 is offline   Reply With Quote
Old 05-14-2010, 02:40 PM   #35
lock

 
lock's Avatar
 
Drives: 11 2SS/RS E-Force Supercharged
Join Date: Apr 2010
Location: Charlotte
Posts: 814
Sweet!
__________________
11 IOM 2SS/RS E-Force Supercharged. 616 RWHP/578 RWTQ. Click link for my journal!!!


lock is offline   Reply With Quote
Old 05-14-2010, 06:36 PM   #36
TeddyP25
 
TeddyP25's Avatar
 
Drives: 2SS
Join Date: May 2009
Location: Fort Collins
Posts: 611
No videos yet, waiting for car to be complete then I will post for sure.
__________________
2SS/RS CGM/BLK GFX MN6418 Stroker.785rwhp/885lbtq.50 SHOT NO2..Pfadt arms,toe links,coilovers,swaybars,end links,engine mounts,dif/sub bushings.MGWshifter.Tick LVL 3.ARH1 7/8 LT's/ARH exhaust.ADM gauges/race CAI.E-FORCE SC.8 rib IW 10%OD.LPE dual pump/module.85lb inj,custom valve covers.RMCR tune.TOOLEY RACING CAM.JRE posi kit.JRE fuel upgrade.RX MONSTER CatchCan.DSS axels/DS.Hammerhead rear, 3:73's. WYOSPEED builthttp://www.camaro5.com/forums/showthread.php?t=115687
TeddyP25 is offline   Reply With Quote
Old 05-14-2010, 07:12 PM   #37
BUMBLEB
IN GOD WE THRUST
 
BUMBLEB's Avatar
 
Drives: 2010 RY 2SS RS M6 TVS2300 2015 Z06
Join Date: Sep 2009
Location: PARKER,CO
Posts: 284
Very nice T
__________________
BUMBLEB is offline   Reply With Quote
Old 05-14-2010, 08:36 PM   #38
GQ4Life


 
Drives: 2010 Camaro SS LS3
Join Date: Aug 2009
Location: Fishkill, NY
Posts: 5,211
Quote:
Originally Posted by RMCR View Post
At our altitude a fuel upgrade is not necessary. If we were at sea level I would recommend a minimum of a booster pump or a twin setup.

Hope this helps.
for safety reason shouldnt the customer look into one.. what if he goes somewhere that is sea level.. the car might go lean under full throttle..

BY the way NICE numbers.. that low end TQ is crazy.. runners are working I guess..
__________________
2015 Corvette Z06.. Lime Rock Park 1:01; Watkins Glen 2:14; Thompson Speedway 1:21
GQ4Life is offline   Reply With Quote
Old 05-14-2010, 09:14 PM   #39
jsharp
NOW CAMMED & SUPERCHARGED
 
jsharp's Avatar
 
Drives: 2010 Camaro 2SS/RS Black w/ IOM
Join Date: Oct 2008
Location: Ar
Posts: 2,340
bump for video!!
__________________
Livernois Motorsports: Maggie 2300 7psi, Livernois 2C cam/L99 to LS3 Conversion, Ported TB, Rotofab w/adm race scoop, adm trans cooler,Kooks headers no cats, Kooks 3" exhaust. METCO breather. Precision 2400 Vigilante TC. Eibach Lowering Springs & Swaybars. BMR Trailing arms, BMR Rear Cradle Bushings, BMR Toe Rods, BMR Differential bushings. Vossen CV3 20's w/ 305 Mickey Thompson @25psi. Zl1 front bumper. OE Zl1 Hood and matte black insert. 556RWHP/500RWTQ L99
jsharp is offline   Reply With Quote
Old 05-14-2010, 09:22 PM   #40
JM10
Se habla espaņol
 
JM10's Avatar
 
Drives: 2010 Camaro SS/RS VR
Join Date: Jun 2009
Location: Arizona/Sonora
Posts: 606
Quote:
Originally Posted by ADM PERFORMANCE View Post
This was the first one that tried our system.

I see a couple small changes and we will have a kit..ASAP

Please let me know when ready!!

My installation begins next tuesday!!!


JM
__________________
2010 VR 2SS/RS
BMR Suspension Parts
Hendrix HD Axles
DSS Aluminum Shaft
RPM Diff / 3.91 Gears
LPE ZR1 Clutch
Edelbrock E-Force SC / JRE Fuel Upgrade
Livernois 1C cam 570 rwhp/559 rwtq SAE
Best 1/4 time: 11.43
JM10 is offline   Reply With Quote
Old 05-14-2010, 10:23 PM   #41
TeddyP25
 
TeddyP25's Avatar
 
Drives: 2SS
Join Date: May 2009
Location: Fort Collins
Posts: 611
Quote:
Originally Posted by GQ4Life View Post
for safety reason shouldnt the customer look into one.. what if he goes somewhere that is sea level.. the car might go lean under full throttle..

BY the way NICE numbers.. that low end TQ is crazy.. runners are working I guess..
Yea its definitely on my list of other upgrades, but for now we are good. There is always a chance of a road trip or somethin, will be doing that before any such trip for sure.
__________________
2SS/RS CGM/BLK GFX MN6418 Stroker.785rwhp/885lbtq.50 SHOT NO2..Pfadt arms,toe links,coilovers,swaybars,end links,engine mounts,dif/sub bushings.MGWshifter.Tick LVL 3.ARH1 7/8 LT's/ARH exhaust.ADM gauges/race CAI.E-FORCE SC.8 rib IW 10%OD.LPE dual pump/module.85lb inj,custom valve covers.RMCR tune.TOOLEY RACING CAM.JRE posi kit.JRE fuel upgrade.RX MONSTER CatchCan.DSS axels/DS.Hammerhead rear, 3:73's. WYOSPEED builthttp://www.camaro5.com/forums/showthread.php?t=115687

Last edited by TeddyP25; 05-14-2010 at 10:54 PM.
TeddyP25 is offline   Reply With Quote
Old 05-15-2010, 11:37 AM   #42
boostedyards86
 
boostedyards86's Avatar
 
Drives: Cummins 3500
Join Date: Jul 2009
Location: Pgh PA
Posts: 611
That car definitely needs a cam.
__________________
85 Buick TType - 5.3l GT4202r 10.86 at 126
boostedyards86 is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Roto-fab CAI dyno results Roto-fab 1 Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 102 07-30-2016 07:21 PM
Edelbrock E Force Supercharger Issue PJ droopy pants Forced Induction - V8 27 01-10-2011 08:21 AM
Edelbrock E Force Supercharger Installed GPC1 Forced Induction - V8 15 05-03-2010 09:21 AM
Edelbrock E-Force Blower on Dyno & Road (video) Hennessey Performance Forced Induction - V8 31 04-20-2010 02:56 PM
E force dyno results Caliman93230 Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10 04-15-2010 10:16 PM


All times are GMT -5. The time now is 04:07 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.