04-01-2019, 02:53 PM | #1 |
Drives: 2014 Camaro RS LT Join Date: Jan 2019
Location: FL
Posts: 14
|
High oil pressure 2014 lfx
Hey guys I have a 2014 LT RS camaro and I noticed the oil pressure was sitting at 2.7-2.8 bar warmed up. From what I read that means it’s idling at about 40 psi? Isn’t that a little high? Also, on acceleration of any type.. not even hard acceleration.. it is reading 6 bar (maxxed out) which is roughly ~85 psi? Is this normal? I just had my oil changed at the dealer a couple months ago.
|
04-01-2019, 04:38 PM | #2 |
Drives: 2015 Chevrolet Camaro 2LT RS Join Date: Aug 2015
Location: Toronto, Ontario
Posts: 271
|
that usually happens when the car isnt warmed up... after driving for 20-30min it goes away
__________________
K&N intake, Custom Tune, Billet Catch Can, K.C's Ported 72mm TB & IM, Jacfab IM Spacer, Primary/Secondary Cat & Muffler Delete, Magnaflow Xpipe, 2.5" Straightpiped, GM Strut Tower Brace, Mace Engineering Cams, Solo Performance J pipes, Magnaflow Resonators x 2
340rwhp Dyno |
04-01-2019, 09:07 PM | #3 |
Drives: 2013 SW 2LT/RS LFX/AY6 Join Date: Feb 2013
Location: Orlando, FL
Posts: 1,741
|
Mine idles around 30# and under acceleration the oil pressure needle is pegged (70) so it sounds about right.
__________________
K&N CAI, 1LE Strut Tower Brace, Elite Engineering Catch Can and Clean Side Separator, Apex Scoop w/ Washer Relocation Kit, CTS Front Calipers and Rotors, JacFab Ported Intake Manifold, JacFab Intake Manifold Spacer, 80mm Overkill Throttle Body, SS Brake Lines, Ideal Garage Master Cylinder, Monster Twin Disc Clutch, NPP Retrofit w/ Magnaflow Resonated X, ARH Catless Downpipes, JRE Built 3.45 Diff, 1LE Axles, 1LE Hubs, Overkill Tuned, BMR Anti Wheel-hop Kit Stage I, ACS TL1 Hood Insert, ZL1 Spoiler
|
04-10-2019, 01:22 PM | #4 |
Drives: 2012 Camaro RS 2LT 6spd man Join Date: Aug 2013
Location: Dickinson, Texas
Posts: 535
|
|
04-13-2019, 05:34 AM | #5 |
Drives: 2010 camaro limited edition turbo Join Date: Mar 2014
Location: saint petersburg, florida
Posts: 499
|
No problem, normal, mine is the same since installing brand new LFX engine.
|
|
|
|
|