11-27-2010, 07:51 AM | #1 |
Drives: 2013 1LT Crystal Red/Beige Manual Join Date: Nov 2008
Location: Stoneham, MA
Posts: 735
|
Very Weird Engine Episode
My car's about 10 months old. So last night, I hopped in it and drove to my friends house. Probably not even 1/4 mi down the road. I go inside, we play with his new TV, play some halo, few hours later I leave. At this point it's about 30° out. So I start it up, and wait for the idle to slow down. As it slows down, it starts to feel rough, and I notice the engine light doesn't go out. I rev it a little but nothing, it keeps running very very rough. I drove home, and the whole way home it was driving very rough, very under-powered, and the engine light was on. I'm thinking oh great, now I have to go drop it off at the dealership. I was about to get out and I wondered what would happen if I started it up again. So I started up again, and it was fine. I drove around for a few minutes, ran perfectly.
So what the hell happened?
__________________
|
11-27-2010, 08:27 AM | #2 |
Drives: 1999 Trans Am Join Date: Jul 2009
Location: Bridgewater,Ma
Posts: 2,017
|
What engine/tranny?
|
11-27-2010, 08:30 AM | #3 |
Drives: 2010 Camaro SS/RS 6spd Join Date: Sep 2009
Location: Jefferson, Ga
Posts: 4,399
|
__________________
|
11-27-2010, 08:44 AM | #4 |
Drives: 04 Silverado Join Date: Jun 2010
Location: Floriduh!
Posts: 1,113
|
The v6 auto I rented did the same thing when cold, but no lights
|
11-27-2010, 01:23 PM | #5 |
Drives: 2010 1ss red Join Date: Oct 2010
Location: puyallup washington
Posts: 7
|
probably was still cold, when cold it is still "choking" the engine. When you shut it off there is still too much fuel and can foul the plugs. When you start it and it misfires the engine managment will kill that cylinder as to not overfuel the catalytic converter. Then, you shut it off and restart it will be normal. Had you shut it off and restarted after a few seconds the problem would have been gone. There will be a misfire code stored in your ecm.
|
11-29-2010, 12:10 PM | #6 |
Drives: 2010 Camaro Auto Join Date: Mar 2010
Location: Fl
Posts: 1,164
|
Why ask people who could not possibly know what the cel was about. Read out the code that is still set in the ECM memory and you will know for sure.
|
11-29-2010, 12:12 PM | #7 |
Drives: 2013 1LT Crystal Red/Beige Manual Join Date: Nov 2008
Location: Stoneham, MA
Posts: 735
|
And how am I supposed to do that?
__________________
|
11-29-2010, 12:15 PM | #8 |
Drives: 2010 Camaro Auto Join Date: Mar 2010
Location: Fl
Posts: 1,164
|
If you don'thave a hand held reader, then go to a Auto parts store like Auto Zone, Advance Auto etc. they can read it out for you.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LS3 engine specifications | Tran | Wiki | 3 | 10-06-2010 10:56 PM |
LLT engine specifications | Tran | Wiki | 2 | 03-29-2010 10:06 AM |
Texas Speed & Performance Fall Engine Sale | Trevor @ Texas Speed | V8 Bolt-Ons & Tunes | 2 | 12-08-2009 10:19 AM |
Why i think you cant do a Dyno in the same day | 2SSRS@Gen5diy | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 123 | 10-22-2009 07:37 PM |
Turbocharge your way to efficiency.....and power! | Mr. Wyndham | Forced Induction - V8 | 20 | 07-06-2008 12:46 PM |