04-17-2012, 11:38 AM | #1 |
Drives: 14 Silverado LTZ Z71, 16 Camaro SS Join Date: Nov 2009
Location: Jackson, Michigan
Posts: 4,407
|
Routing Gauge Wires
I recently purchased a Fesler single gauge pod A-piller as well as an Aeroforce Interceptor Scan gauge/shift light.
This unit plugs directly into the OBD2 port underneath the drivers side steering wheel. I havent got into it yet but I was wondering where I should take the wire from the gauge to get it down to the OBD2 connector. I would prefer the wire to come out where it cant be seen underneath where the foot pedals are etc. Anyone have any similar experience/installs to give me some tips? Thanks, Troy |
04-18-2012, 06:34 PM | #2 |
Drives: 2010 2SS/RS M6 Join Date: Jan 2010
Location: Delray Bch
Posts: 113
|
run it down the pillar, pop the fuse panel on the side of the drivers dash continue to run wires until under the dash. you are right there.
|
04-18-2012, 07:01 PM | #3 | |
Drives: 14 Silverado LTZ Z71, 16 Camaro SS Join Date: Nov 2009
Location: Jackson, Michigan
Posts: 4,407
|
Quote:
I was hoping for something similar...just havent looked yet. Gauge still isnt here...hopefully it isnt too much of a PITA |
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MTI Racing Colored Plug Wires | MTI Racing Kevin | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 31 | 07-23-2017 09:47 AM |
Brand New AEM Gauges For Sale | gotpball44 | Audio / Visual / Electronics/ Gauges / Nav | 1 | 08-16-2011 07:06 PM |
Brand New AEM Gauges For Sale | gotpball44 | Local Marketplace | 0 | 08-13-2011 06:28 PM |
MTI Racing Colored Plug Wires | MTI Racing Kevin | V8 Bolt-Ons & Tunes | 0 | 09-30-2010 04:27 PM |
AeroForce Interceptor Gauge Install | tjd24 | Audio / Visual / Electronics/ Gauges / Nav | 7 | 10-21-2009 08:38 AM |