Break Squeeeeek (SS)

[WHLnDEAL]

I need to thank you all for helping me with the DOD change to eliminate exhaust drone, but the break squeak problem never seems to go away, and I'm at wits end. My 2011 SS does not have the "roller skates", and I have changed pads to Hawk ' performance ceramics, with no change. I've completely torn down the front and rear breaks, and applied all the Permatex grease previously discussed on this forum. The problem never seems to go away.

What's available after market, for a complete swap out? Brembro "big brakes"? Has antbody taken the $$$ hit yet? If so, how was your experience?

Thanks, Dennis

[toehead93]

How do you use your car? I plan on upgrading to CTS-V brakes personally for my 2014 1LE. However, if you don't really track the car it is not needed and you could just swap to Hawk HPS pads or ceramic pads. If you do track occasionally like I do the it may be worth the upgrade.

[WHLnDEAL]

Mostly a summer cruiser, less than 3k miles on vehicle.

[JDP Sales]

Did you properly bed in the pads? Also, sometimes small contaminants and road debris can get cought in the pad causing the squealing. Try cleaning up the pads and rotors with some sand paper and re bedding them using the bedding process below.

Originally Posted by Hawk

After installing new pads make 6 to 10 stops from approximately 35 mph with moderate pressure. Make an additional two to three hard stops from approximately 40 to 45 mph. Do not allow the vehicle to come to a complete stop.When completed with this process, park the vehicle and allow the brakes to cool completely before driving on them again. Do not engage the parking brake until after this cooling process is compete.

Best regards,

Tyler
888-308-6007

[The Stig]

Here you go OP:

http://www.camaro5.com/forums/showthread.php?t=189890

[Team STILLEN]

Originally Posted by Sales@JDP

Did you properly bed in the pads? Also, sometimes small contaminants and road debris can get cought in the pad causing the squealing. Try cleaning up the pads and rotors with some sand paper and re bedding them using the bedding process below.



Best regards,

Tyler
888-308-6007

Originally Posted by The Stig

Here you go OP:

http://www.camaro5.com/forums/showthread.php?t=189890

This right here.

If you REALLY want to do a complete upgrade, we have an AP Racing Big Brake kit available.



Please let me know if you have any questions.

Thanks

JT

[WHLnDEAL]

Hey guys, thanks again for all your help, used the link provided:

http://www.camaro5.com/forums/showthread.php?t=189890

Completed the project last Sunday and have driven 500+ miles this week, with no noise.

WHLnDEAL